Today modern simulations solutions in the wind turbine industry have achieved a high degree of complexity and detail in result. Limitations exist when it is time to validate model results against measurements. Regarding Model validation it is of special interest to identify mode frequencies and to differentiate them from the different excitations. A wind turbine is a complex device and measurem...

Wind is one of the cheapest and widely source of alternative energy. To convert it into electrical energy a wind turbine with generator is used but to properly convert this wind energy into electrical energy proper design of wind turbine is needed. In this paper we presents a genetic algorithm based optimization technique for the estimation of wind turbine parameters on the basis of requirement...

This paper reports on our research in developing a micro power generation system based on gas turbine engine and piezoelectric converter. The micro gas turbine engine consists of a micro combustor, a turbine and a centrifugal compressor. Comprehensive simulation has been implemented to optimal the component design. We have successfully demonstrated a silicon-based micro combustor, which consist...

To enable wind turbines to produce power under great variety of wind conditions a sophisticated control system is needed. Wind turbine system is highly nonlinear and its dynamic changes rapidly with the change of wind speed. Besides this, wind turbine mechanical structure is very flexible due to its great height and tends to oscillate. All this makes the design of wind turbine control system ve...

Vertical axis wind turbine blades undergo dynamic stall due to the large 1 angle of attack variation they experience during a turbine rotation. Particle image 2 velocimetry on a pitching and surging airfoil was used to perform time resolved 3 measurements at blade Reynolds numbers near turbine operating conditions of 105. 4 These experiments were compared to simulations performed in the rotatin...

Turbine blades are high value castings having complex internal geometry. Computed Tomography has been employed on Turbine blades for finding out defects and internal details. The wall thickness, rib thickness and radius of curvature are measured from the CT slices. The discontinuities including blockages of cooling passages in the cast material can be detected. 3D visualization of the turbine b...

Individual wind turbines in a wind farm typically operate to maximize their performance with no consideration of the impact of wake effects on downstream turbines. There is potential to increase power and reduce structural loads within a wind farm by properly coordinating the turbines. To effectively design and analyze coordinated wind turbine controllers requires control-oriented turbine wake ...

Measurements have been made in the wake of a model wind turbine in both a weakly unstable and a baseline neutral atmospheric boundary layer, in the EnFlo stratified-flow wind tunnel, between 0.5 and 10 rotor diameters from the turbine, as part of an investigation of wakes in offshore winds. In the unstable case the velocity deficit decreases more rapidly than in the neutral case, largely becaus...

The type of turbine developed is based on the very low head of water potential source for the electric power production. The area of research is focused for the axial water turbine that can be applied at the simple site open channel with has a very low cost and environmental impact compared to the conventional hydro installation. High efficiency of axial turbine which applied to the very low po...