Measuring heat flux out or into a process surface is of significant practical interest. Miniaturization of the sensor and the capability of dynamic sensing are highly desirable. In this paper, the theoretical basis of a heat flux sensor ‘pen’ idea has been established, which allows for real-time measurements. Here the thin temperature measuring wires (thermocouple) are used as the heat flux sen...

Christopher L. Chapman, and Seri Lee Aavid Engineering, Inc. Laconia, New Hampshire 03247 Bill L. Schmidt Silicon Graphics Computer Systems Mountainview, California 94039 Comparative thermal tests have been carried out using aluminum heat sinks made with extruded fin, cross-cut rectangular pins, and elliptical shaped pins in low air flow environments. The elliptical pin heat sink was designed t...

Small amounts of useful power may be generated in polar or subpolar regions during the winter period by placing a heat engine between a large body of water (near PC), acting as a heat source, and the atmosphere (near -25OC), acting as a heat sink. The scheme consists of a fuelless modular system operating on the Carnot cycle. Power is extracted by a reciprocating vapour engine drawing saturated...

As the temperature of electronic devices increases, their failure rate increases. That is why electrical devices should be cooled. One of the promising cooling techniques is using Phase Change Materials (PCMs). A new passive temperature management technique, that involves the direct placement of PCMs on the chip, has been explored and developed. PCMs are potential temperature regulators that ca...

A three-dimensional numerical model of thermoelectric generator (TEG) modules attached to a large chimney plate is proposed and solved numerically using a control volume based finite difference formulation. The TEG module consists of a thermoelectric generator, an elliptical pin-fin heat sink, and a cold plate for water cooling. In the chimney, the temperature of flue gases is 450-650K. Althoug...

Studies using commercial computational fluid dynamics software, running on a supercomputer, were carried out to investigate the effects of fin density, inlet duct velocity, and clearance area ratio, on the extent of flow bypass and its impact on the thermal performance of the heat sink. Flow bypass was found to increase with increasing fin density and clearance, while remaining relatively insen...

Cellular materials have properties similar to conventional materials on the macroscopic level but possess several advantages at the microscopic level, including the ability to be manufactured down to a very small scale. With this ability, new geometric configurations for a heat sink are able to be considered. This paper details the results of a study to develop a geometry based optimization too...

This paper describes a solar-thermal run Stirling engine based uninterrupted power generating system employing magnesium sulphate impregnated Zeolite pellets for thermal energy storage. In the proposed system, Stirling engine design is based on the average temperature difference of 480 C, assuming the heat sink temperature equal to the ambient temperature of that place. In presence of sun, Fres...