The aluminum bronze matrix alumina composites using hot press and resin infiltration were investigated to study their porosities, hardness, bending strengths, and microstructures. The experiment results show that the hardness of the sintered composites with the decrease of porosity increases. The composites without and with resin infiltration have about HRF 42-61 of about 34-40% of porosity and...

condensation reaction of urea, casein and formaldehyde in the presence of varying proportion of resorcinol under alkaline condition. All the prepared resins were characterized by free-formaldehyde content, free-phenol content, viscosity measurements and infrared spectroscopy (IR). The resin samples were cured isothermally at 120oC using two different curing agents, p-toluene sulphonic acid (PTS...

The resin flow behavior in the vacuum assisted resin infusion molding process (VARI) of foam sandwich composites was studied by both visualization flow experiments and computer simulation. Both experimental and simulation results show that: the distribution medium (DM) leads to a shorter molding filling time in grooved foam sandwich composites via the VARI process, and the mold filling time is ...

OBJECTIVES Adhesion of resin composites to dentin is currently believed to result from impregnation of adhesive resin into superficially demineralized dentin. The purpose of this study was to use micro-Raman spectroscopy and scanning electron microscopy (SEM) to investigate the extent of resin penetration into etched dentin with single-step adhesive systems. METHODS Adhesive systems used were...

In this study, carbon nano fibers (CNFs) were mixed into epoxy resin through a magnetic stirrer and again mixed using ultra sonicator. Using hand layup technique, biaxial braided fiber composites were prepared with unfilled, 0.2, 0.5 and 1 wt% CNF. Tensile test and shear test was performed to identify the tensile strength and shear strength of the composites. Fractured surface of the tensile sp...

Resin composites were first introduced as anterior restorative materials, but are more and more used in posterior teeth, as amalgam replacements. Nowadays the so-called ‘condensable’ composites are frequently used in posterior teeth. These materials are subjected to high values of contact and mastigatory loads, loading rates and sliding distances. In such contact conditions, wear is the major f...

OBJECTIVE To compare the performance and postoperative sensitivity of a posterior resin composite with that of bonded amalgam in 40 (n = 20) large sized cavities and to evaluate whether resin composite could be an alternative for bonded amalgam. MATERIALS AND METHODS This was a randomized clinical trial. Twenty patients in need of at least two posterior restorations were recruited. Authors ra...

Natural fibers can be attractive reinforcing materials in thermosetting polymers due to their low density and high specific mechanical properties. Although the research effort in this area has grown substantially over the last 20 years, manufacturing technologies to make use of short natural fibers in high volume fraction composites; are still limited. Natural fibers, after retting and preproce...

INTRODUCTION Today, development of materials technology using biomass is expected for creation of a sustainable society. Especially, the composite consisting of plant-based natural fibers and biodegradable resin, so-called the fully-green composites, is much expected for practical use. So far, we made textile green composites using biodegradable resin and plain woven ramie fabric and explored t...

Coupling of fiber posts to composites is hampered by absence of chemical union between epoxy resins and methacrylate-based resins. This study examined a clinically feasible protocol for creating micromechanical retention on the surface of fiber posts, using hydrogen peroxide etching to remove the surface layer of epoxy resin. This was followed by silanization of the exposed quartz fibers to enh...