This case study presents a method of utilizing computer-aided design technologies to provide bespoke, external breast prostheses. The technique is illustrated through a case study of a mastectomy patient. Photogrammetry methods were used to capture the breast form when supported by a brassiere and the unsupported breast and defect side. Computer-aided design techniques were used to generate a d...

Reverse shoulder arthroplasty may be performed using components that medialize or lateralize the center of rotation. The purpose of this prospective study was to directly compare 2 reverse shoulder arthroplasty designs. Two treatment groups and 1 control group were identified. Group I comprised 9 patients using a medialized Grammont-style (GRM) prosthesis with a neck-shaft angle of 155°. Group ...

UNLABELLED Although the design features of the Medial Pivot fixed-bearing prosthesis reportedly improve kinematics compared with TKAs using fixed-bearings, clinical improvements have not been reported. We asked whether the clinical and radiographic outcomes, ranges of motion of the knee, patient satisfaction, and complication rates would be better in knees with a Medial Pivot fixed-bearing pros...

The load on the prosthetic side and the influence of the design on the remaining natural contralateral TMJ must be known before a unilateral temporomandibular joint (TMJ) prosthesis can be developed. The aim of the present study was to determine the maximum loading of the TMJ prosthetic side and the natural contralateral TMJ and to investigate the influence of the location of the center of rota...

OBJECTIVES/HYPOTHESIS Primary tracheoesophageal puncture (TEP) is a well-described and accepted method of surgical voice restoration and is standardly completed with a catheter placement intraoperatively, which is replaced with a prosthesis at a later date. This study evaluates the intraoperative placement of the voice prosthesis at the time of the primary TEP in an effort to understand the pot...

This article presents a virtual prototyping study of a semi-active lower limb prosthesis to improve the functionality of an amputee during prosthesis-environment interaction for level ground walking. Articulated ankle-foot prosthesis and a single-axis semi-active prosthetic knee with active and passive operating modes were considered. Data for level ground walking were collected using a photogr...

In a biomechanical analysis of the forces transmitted to an amputated limb by a below-knee patellar-tendon-bearing prosthesis, R@di% (1) showed in 1962 that the principal forces occur in the patellar ten bn, the distal anterior tibial, the latera tibial condylar, and the medial tibial condylar regions. Apparantly the design of this prosthesis was such that the forces were directed to those area...

The success of any prosthetic design depends on proper management of the occlusion. The clinical variables influencing occlusal stability must be determined and considered in the design of the final prosthesis. This paper outlines some of these variables.

This paper presents an anthropomorphic prototype hand prosthesis that is intended for use with a multiple channel myoelectric interface. The hand contains 16 joints, which are differentially driven by a set of five independent actuators. The hand prototype was designed with the minimum number of independent actuators required to provide a set of eight canonical hand postures. This paper describ...