Solid-state direct diffusion bonding of commercially pure Titanium (Cp-Ti) and precipitation hardening stainless steel (PHSS) has been carried out in the temperature range of 800°C to 1000°C with an interval of 50°C for 3.6 ks under 3.5 Mpa uniaxial load in (4 to 6)×10 Pa vacuum. The effects of temperatures have been investigated with reference to bond strength. The examination revealed that th...

The effects of copper on the ageing precipitation behavior of as-quenched and pre-aged AA6016 aluminum alloy were studied by differential scanning calorimetry (DSC), Vickers hardness measurement and transmission electronic microscopy (TEM). The results indicate that the addition of copper facilitates the growth of clusters (GP I) to the critical size during pre-ageing. Therefore, the addition o...

The present study contains a critical review of work on the formation of precipitates and intermetallic phases in dilute precipitation hardening Al–Cu–Mg based alloys with and without Li additions. Although many suggestions for the existence of pre-precipitates in Al–Cu–Mg alloys with a Cu/Mg atomic ratio close to 1 have been made, a critical review reveals that evidence exists for only two tru...

Purpose: The goal of the study is to research the effect of various time of ageing on corrosion resistance, hardness and structures of Remanium 2000+ Co-Cr-Mo alloys used in prosthodontia. Design/methodology/approach: To investigation was prepared mould, cast in 1430°C and realized the heat treatment: solutioning in 1250°C by 3 hours and then ageing in 850°C by 4, 8, 16 and 24 hours. Electroche...

This work demonstrates a novel application of ultrasound: measurement of magnetostriction, the change of length of a ferromagnetic material that accompanies a change in magnetization. The technique involves measuring ultrasonic waves generated by an electromagnetic acoustic transducer (EMAT), and it offers an alternative method of measuring magnetostriction in cases where it would not be feasib...

This report may be updated and revised periodically in response to the needs of the technical community; up-to-date versions can be requested from the editors at the address given below or downloaded at http://www.ca.sandia.gov/matlsTechRef/. The content of this report will also be incorporated into a Sandia National Laboratory report (SAND2008-1163); the most recent version can be obtained fro...

A methodology to simulate paraequilibrium (PE) growth in multicomponent systems using the DICTRA (Diffusion-Controlled Transformation) software is presented. For any given multicomponent system containing substitutional and interstitial elements, the basic approach is to define a hypothetical element Z, whose thermodynamic and mobility parameters are expressed in terms of the weighted average (...

The Bauschinger effect (BE) in single crystals of Hadfield manganese steel (Fe, 12.3Mn, 1.0C in wt pct) was studied for three crystallographic orientations, [111], [123], and [001]. Both forward tensionreverse compression (FT/RC) and forward compression-reverse tension (FC/RT) loading schemes were used to investigate the role of deformation history on the BE. The evolution of stress-strain resp...

In the present study, mechanical properties and low cycle fatigue behavior of a solid-solutionized AA6061 aluminum alloy produced by equal channel angular pressing (ECAP) process were investigated. The grain refinement after two passes of ECAP significantly increased the yield stress and ultimate tensile stress and decreased the ductility of the alloy. However, the improvement of low cycle fati...