Enclosed is a set of page proofs of your article entitled “Acoustic Wave Propagation in a Composite of Two Different Poroelastic Materials with a Very Rough Periodic Interface: A Homogenization Approach.” Whether this proof comes to you as a PDF file or a fax, please email us immediately at the address above that you have received it. No article will be published without confirmation of the aut...

Abstract Induced seismicity is a limiting factor for the development of Enhanced Geothermal Systems (EGS). Its causal mechanisms are not fully understood, especially those post-injection seismicity. To better understand that induced in controversial case Basel EGS (Switzerland), we perform coupled hydro-mechanical simulation plastic response discrete pre-existing fault network built on basis mo...

The modus operandi of “modeling weeks” is explained and illustrated using a classical modeling week problem of subjecting coconuts to an external pressure before splitting them open, in the hope that the coconut meat will then separate easily from the shell. A range of modeling approaches is considered, and a poroelastic model is posed that allows the key problem parameters to be identified and...

In this work a continuum model for high frequency poroelastic longitudinal waves in hydrogels is presented. A viscoelastic force describing the interaction between the polymer network and the bounded water present in such materials is introduced. The model is tested by means of ultrasound wave speed and attenuation measurements in polyvinylalcohol hydrogel samples. The theory and experiments sh...

Measurements and predictions have been made of the absorption coefficient and the surface acoustic impedance of poroelastic plates clamped in a large impedance tube and separated from the rigid termination by an air gap. The measured and predicted absorption coefficient and surface impedance spectra exhibit low frequency peaks. The peak frequencies observed in the absorption coefficient are clo...

In this work, we consider the spatial homogenization of a coupled transport and fluid-structure interaction model, to the end of deriving a system of effective equations describing the flow, elastic deformation and transport in an active poroelastic medium. The 'active' nature of the material results from a morphoelastic response to a chemical stimulant, in which the growth time scale is strong...

In this paper, the basic constitutive equations and equations of motion are derived to describe the behavior of thermoelastic porous piezoelectric medium by using Biot’s theory and the theory of generalized thermoelasticity with on relaxation time (Lord-Shulman). The electrical enthalpy density function is derived in the general coordinates. Also, clear definitions for the poroelastic modulus, ...

in this paper, bam postseismic deformations during 7 years after earthquake have been extracted using persistent scatterer interferometry technique. the time series are inverted for the afterslip distribution on an extension of the coseismic rupture. the estimated postseismic slip value is 20.45±0.38 cm. most of the postseismic displacement field can be explained in terms of fault slip. the res...

In an infusion test the apparent rate of cerebrospinal fluid (CSF) production is temporarily increased through injection of fluid directly into the CSF system with the result that CSF pressure rises, in theory to a new plateau average, and the change in pressure level gives a measure of resistance to CSF outflow and the rate of approach to the plateau gives information about cerebral compliance...

Colloidal-probe spherical indentation load-relaxation experiments with a probe radius of 3 μm are conducted on poly(ethylene glycol) (PEG) hydrogel materials to quantify their steady-state mechanical properties and time-dependent transport properties via a single experiment. PEG-based hydrogels are shown to be heterogeneous in both morphology and mechanical stiffness at this scale; a linear-har...