In this paper, stabilization of a Rayleigh beam with collocated piezoelectric sensor/actuator is studied. With linear output feedback law, several stability results are achieved. The the closed-loop system depends on location actuator. sufficient and necessary conditions for strong provided. For almost all choices ends actuator, energy decreases to zero in polynomial way explicit decay rate obt...

Piezoelectric actuation is widely used for the active vibration control of smart structural systems, and corresponding research has largely focused on linear electromechanical devices. This paper investigates the design and analysis of a novel piezoelectric actuator that uses a piezoelectric cantilever beam with a loading spring to produce displacement outputs. This device has a special nonline...

We demonstrate a low-power (<0.1 mW), low-voltage (<10 V(p-p)) on-chip piezoelectrically actuated micro-sorter that can deflect single particles and cells at high-speed. With rhodamine in the stream, switching of flow between channels can be visualized at high actuation frequency (micro1.7 kHz). The magnitude of the cell deflection can be precisely controlled by the magnitude and waveform of in...

C-blocks are unique piezoelectric building blocks which can be combined in series or parallel to generate tailorable performance and exploit the advantages of bender and stack architectures. This paper presents a complete theoretical model that predicts the force-deflection behavior for any generic C-block actuator array configuration. An experimental investigation with five case studies is des...

We present an ultra-thin meso scale piezoelectric actuator consisting of a piezoceramic beam and a carbon fiber displacement-amplification frame. We show that the actuator can be designed to achieve a wide range of force/displacement characteristics on the mN/μm scales. The best performing design achieved a free displacement of 106 μm and a blocked force of 73 mN, yielding a total energy densit...

A control system for a piezoelectric beam actuator, which had one or two inputs, was subject of numerical and laboratory research. The actuator prismatic shape with rectangular cross-section consisted layer carrying substrate made from PCB-FR4 patches Macro Fiber Composite P1 type. MFC were glued on both sides the substrate. An article presents comparison quality signal (one-input actuator) sig...

The behaviour of a piezoelectric actuator is strongly affected by the bonding condition along the interface between the actuator and the host structure. The current paper represents an analytical study of the static effect of the mechanical and geometrical properties of the adhesive layer on the coupled electromechanical behaviour of a thin piezoceramic actuator bonded to an elastic medium. An ...

Through resent years new high performing Dielectric Electro Active Polymers (DEAP) have emerged. To fully utilize the potential of DEAPs a driver with high voltage output is needed. In this paper a piezoelectric transformer based power supply for driving DEAP actuators is developed, utilizing a burst mode control technique. Controlling and driving a DEAP actuator between 250V to 2.5kV is demons...