The adsorption properties of olive wood (OW) toward phenol, 2-chlorophenol, 3-chlorophenol, 4-chlorophenol, 2-nitrophenol, 4-nitrophenol and 2,4-dinitrophenol, were improved by washing OW with some organic solvents (ethanol, tetrahydrofuran, ether, dichloromethane or hexane). Adsorption isotherms were classified according to Giles and Smith classification, in which L2-shape was obtained after O...

A substantive approach converting waste date pits to mercerized mesoporous date pit activated carbon (DPAC) and utilizing it in the removal of Cd(II), Cu(II), Pb(II), and Zn(II) was reported. In general, rapid heavy metals adsorption kinetics for Co range: 25-100 mg/L was observed, accomplishing 77-97% adsorption within 15 min, finally, attaining equilibrium in 360 min. Linear and non-linear is...

The purpose of this study was to elucidate the characteristics and mechanisms of adsorption and desorption for heavy metals by micro and nano-sized biogenic CaCO3 induced by Bacillus subtilis, and the pH effect on adsorption was investigated. The results showed that the adsorption characteristics of Cd2+ and Pb2+ are well described by the Langmuir adsorption isothermal equation, and the maximum...

1 For virtually any physical adsorption process, the capacity of an adsorbent decreases as the temperature of the system increases. As the temperature increases the adsorbed molecules acquire sufficient energy to overcome the van der Waals’ attraction, holding them in the condensed-phase and migrating back to the gas-phase. Adsorption is an exothermic process. At low concentrations the heat rel...

Fennel seed spent (FSS)-an inexpensive nutraceutical industrial spent has been used as an efficient biosorbent for the removal of Congo red (CR) from aqueous media. Results show that the conditions for maximum adsorption would be pH 2-4 and 30°C were ideal for maximum adsorption. Based on regression fitting of the data, it was determined that the Sips isotherm (R2 = 0.994, χ2 = 0.5) adequately ...

Adsorbed natural gas has various advantages and is relatively more economical than liquefaction and compression. Carbon nanotubes can be introduced as a new candidate for natural gas storage. In this study, adsorption of methane was firstly studied on the as-prepared multi-walled carbon nanotubes, and then chemical and physical treatment of MWCNTs was performed to enhance the methane adsorp...

   In this study the adsorption of selenium molecule (Se2) on the outer surface of zigzag (5,0), (8,0) and (10,0) carbon nanotubes has been investigated. We examined number adsorbed orientations as well as different adsorption sites on nanotubes. The adsorption energies, equilibrium distances, energy differences between the highest occupied molecular orbital (HOMO) and lowest uno...

PURPOSE The aim of this study was to evaluate the stability of arginine-glycine-aspartic acid (RGD) peptide coatings on implants by measuring the amount of peptide remaining after installation. MATERIALS AND METHODS Fluorescent isothiocyanate (FITC)-fixed RGD peptide was coated onto anodized titanium implants (width 4 mm, length 10 mm) using a physical adsorption method (P) or a chemical graf...

Biosensors based on landscape phages immobilized by physical adsorption on the surface of a quartz crystal microbalance was used for detection of beta-galactosidase from Escherichia coli. The sensor had a detection limit of a few nanomoles and a response time of a approximately 100 s over the range of 0.003-210 nM. The binding dose-response curve had a typical sigmoid shape and the signal was s...