An isolated switched high step up boost DC-DC converter is discussed in this paper. The main objective of this paper is to step up low voltage to very high voltage. This paper mainly initiates at boosting a 30V DC into 240V DC. The discussed converter benefits from the continuous input current. Usually, step-up DC-DC converters are suitable for input whose voltage level is very low. The circuit...

The flying-capacitor (FC) topology is one of the more well-established ideas of multilevel conversion, typically applied as an inverter. One of the biggest advantages of the FC converter is the ability to naturally balance capacitor voltage. When natural balancing occurs neither measurements, nor additional control is needed to maintain required capacitors voltage sharing. However, in order to ...

In this work a new embedded negative voltage level converter is presented. The proposed circuit converts a positive input signal to a negative output signal obtaining an increased protection by the high voltage stress on the used MOS devices. This results in higher system reliability in applications where negative pulses are required. The circuit has been designed in a 0.18μm triple-well standa...

We investigate the subtle effects of diffuse charge on interfacial kinetics by solving the governing equations for ion transport (Nernst-Planck) with realistic boundary conditions representing reaction kinetics (Butler-Volmer) and compact-layer capacitance (Stern) in the asymptotic limit ǫ = λD/L → 0, where λD is the Debye screening length and L is the distance between the working and counter e...

Based on the fact that the real inductor and the real capacitor are fractional order in nature and the fractional calculus, the transfer function modeling and analysis of the open-loop Buck converter in a continuous conduction mode (CCM) operation are carried out in this paper. The fractional order small signal model and the corresponding equivalent circuit of the open-loop Buck converter in a ...

This paper presents a design study of a new topology for miniaturized bondwire transformers fabricated and assembled with standard IC bonding wires and toroidal ferrite (Fair-Rite 5975000801) as a magnetic core. The microtransformer realized on a PCB substrate, enables the build of magnetics on-top-of-chip, thus leading to the design of high power density components. Impedance measurements in a...

This study proposes a method which consists of High step up DC-DC converter with a coupled inductor for distributed generation system. Theoretically the conventional boost converter provides high step up voltage gain but in practical it is limited by reverse recovery problem of diode, effective series impedance of inductors and capacitors and switching losses. High charged current and conductio...

This paper presents a simple, high-speed, high-linear V-I converter that has the sumple/liold (S/H) function xid can be operated under low voltage supply. The converter will be used ;IS the “front cnd” o f current-mode signal proccssors. The proposed V-1 ccwvcrter circuit is coinprised of a current copier and a sinal1 resistor that can be realized on chip by using polvsilicoii. The current copi...

This paper investigates the operation of a currentcontrolled Voltage Source Converter (VSC) under weakgrid conditions caused by large grid impedance. Threedifferent current controller structures are investigated; theconventional decoupled PI-controller in the synchronouslyrotating reference frame, Proportional Resonant (PR)controllers in the stationary reference frame, a...

DC-DC converter is a converter where we are regulating the input voltage to get the desired output voltage which is either greater than or equal to or less than the input voltage with positive or negative polarity. A lot of dc-dc converters are available in the world out of which SEPIC (Single-Ended Primary-Inductor Converter) converter is one of them. To analyse the converter, a lot of techniq...