Al-5Ti-C master alloy was prepared and used to modify hypereutectic Al-20%Si alloy. The microstructure evolution and mechanical properties of hypereutectic Al-20%Si alloy with Al-5Ti-C master alloy additions (0, 0.4, 0.6, 1.0, 1.6 and 2.0 wt%) were investigated. The results show that, Al-5Ti-C master alloy (0.6 wt%, 10 min) can significantly refine both eutectic and primary Si of hypereutectic ...

Microstructure imaging from diffusion magnetic resonance (MR) data represents an invaluable tool to study non-invasively the morphology of tissues and to provide a biological insight into their microstructural organization. In recent years, a variety of biophysical models have been proposed to associate particular patterns observed in the measured signal with specific microstructural properties...

Objective: To study ocular manifestations in patients who were on long-term use of chlorpromazine. Methods: A retrospective observational case study was made. Three patients, who were diagnosed as Schizophrenia and on long-term use of chlorpromazine for more than 20 years, were examined retrospectively. The examinations included clinical history, physical examination, slit-lamp biomicroscopy, a...

The microstructure and tensile properties of the thixoforged in situ Mg2Sip/AM60B composite were characterized in comparison with the as-cast composite and thixoforged AM60B. The results indicate that the morphology of α-Mg phases, the distribution and amount of β phases and the distribution and morphology of Mg2Si particles in thixoforged composite are completely different from those in as-cas...

The influence of spray parameters on the microstructure and flexural strength of plasma-sprayed alumina was investigated. Coatings were applied using a small-particle plasma spray (SPPS) method, which is a recently patented process that allows submicrometer-sized powders to be sprayed. Using identical starting powders, coatings that were produced using two distinctly different spray conditions ...

Titanium oxide (TiO2) thin films were deposited by RF magnetron sputtering on Si and glass substrates. The microstructure, surface morphology, and optical properties of the thin films were investigated by grazing incidence X-ray diffraction (GIXD), transmission electron microscopy (TEM), field emission scanning electron microscopy (FE-SEM), atomic force microscopy (AFM), and UV/VIS spectrophoto...

[1] A multiscale methodology for the determination of the macroscopic optical properties of snow is presented. It consists of solving the coupled volume-averaged radiative transfer equations for two semi-transparent phases – ice and air – by Monte Carlo ray tracing in an infinite slab via direct pore-level simulations on the exact 3D microstructure obtained by computed tomography. The overall r...

In the present study, the Weldability and microstructure of dissimilar welds of AISI 347austenitic stainless steel to ASTM A335 low alloy steel was investigated. For this purpose, gas tungsten arc welding process and two filler metals including ERNICr-3 and ER309L were used. After welding, the microstructure of the different zones of each joint, including weld metals, heat affected zone (HAZ) 1...

TiCl4, ammonia, inorganic salts as raw material, nanometer composite-crystal TiO2 powders were synthesized by two-step chemical method. Precursors were crystallized with different phase and stable composite-crystal TiO2 with anatase and rutile phase was prepared at low temperature. Quantitative control of crystal phase was realized. Remarkable factors includ...

In this study, several examples of hydrogels and nanocomposite hydrogels based on PVP with different content of montmorillonite nanoclay were prepared. Then, the swelling of hydrogels and kinetics of drug delivery of hydrogel in an environment similar to the body (pH 7.4) were examined. The effect of nanoparticle different percentages on the hydrogel was clearly observed. Then kinetics of drug ...