Mode II delamination toughness of z-pin reinforced composite laminates is investigated using finite element (FE) method. The z-pin pullout process is simulated by the deformation and breakage of non-linear springs. A critical shear stress criterion based on linear elastic fracture mechanics is used to simulate crack growth in an end-notched-flexure (ENF) beam made of z-pinned laminates. The mod...

Electrical tomography can be used as a structural health monitoring technique to identify different damage mechanisms in composite laminates. Previous work has established the link between transverse cracking density and mesoscale conductivity of the ply. Through the mesoscale relationship, the conductivity obtained from electrical tomography can be used as a measure of the transverse cracking ...

This paper presents the results from an experimental study on the actuation response of composite laminates containing Shape-Memory Alloy (SMA) actuators. Unidirectional glassfibre reinforced epoxide laminates were constructed containing Ni-Ti SMA actuators orientated parallel to the glass-fibre direction. The volume fraction of actuator was varied in the range 0 to 2.5 ~ 0 1 % . These laminate...

The moisture absorption behavior and the influence of moisture on thermal and mechanical properties of glass–fiber/polyetherimide (PEI) laminates have been investigated. The laminates were exposed to hydrothermal aging at two different temperatures and high moisture rates. The properties of as-received and hydrothermally aged samples were compared. The hydrothermally aged laminates contained a ...

This case report describes a patient with discolored and fractured composite resin restorations on the anterior teeth in whom substitution was indicated. After wax-up and mock-up, the composite was removed and replaced with minimally invasive ceramic laminates. An established and predictable protocol was performed using resin cement. Minimally invasive ceramic restorations are increasingly bein...

This paper describes the experimental investigation on the effect of ply thickness on the first ply failure, delamination, and the subsequent final failure of graphite/epoxy composite laminates. The laminates considered in this paper are a cross-ply and two quasi-isotropic laminates containing thin plies in the desired interface. The onset of the first ply failure and delamination, and the stre...

In this article, hybrid composite laminates with shape memory alloy (SMA) and glass fiber (GF) as the reinforced phase, and epoxy resin as the host material, were manufactured by vacuum-assisted resin injection (VARI) processing. The SMA wires were embedded into the GF/epoxy composites with three kinds of modes. The effect of SMA content and the position on the flexural, low-velocity impact per...