[1] Mountain building at convergent margins requires tectonic forces that can overcome frictional resistance along large-scale thrust faults and support the gravitational potential energy stored within the thickened crust of the orogen. A general, dynamic model for this process is still lacking. Here we propose that mountain belts can be classified between two end-members. First, those of “slab...

The problem of calculating transient heat transfer in concrete floor slabs is complicated due to ground coupling, which can require the numerical solution of two or three-dimensional transient conduction equations. This paper presents a simplified method for calculating transient slab-on-ground heat transfer that can be incorporated within hourly simulation programs. The method assumes that the...

The analysis of magmatic distribution, basin formation, tectonic evolution and structural styles of different segments of the Andes shows that most of the Andes have experienced a stage of flat subduction. Evidence is presented here for a wide range of regions throughout the Andes, including the three present flat-slab segments (Pampean, Peruvian, Bucaramanga), three incipient flat-slab segment...

Reinforced concrete (RC) slabs exhibit complexities in their structural behavior under load due to the composite nature of the material and the multitude and variety of factors that affect such behavior. Current methods for determining the load-deflection behavior of reinforced concrete slabs are limited in scope and are mostly dependable on the results of experimental tests. In this study, an ...

When a circularly polarized plane wave is normally incident on a slab of a structurally chiral material with local 4̄2m point group symmetry and a central twist defect, the slab can function as either a narrowband reflection hole filter for co–handed plane waves or an ultranarrowband transmission hole filter for cross–handed plane waves, depending on its thickness and the magnitude of the applie...

The Epping to Chatswood Rail Link (ECRL) commenced operating in 2009. At the Chatswood end of the project, the railway corridor contains two existing tracks (with conventional ballast and sleeper design) and two new concrete slab tracks, the design of which incorporates sections of low stiffness rail fasteners and floating slab track. During commissioning, noise measurements were undertaken at ...

S U M M A R Y We use numerical models to investigate the dynamics of two interacting slabs with parallel trenches. Cases considered are: a single slab reference, outward dipping slabs (out-dip), inward dipping slabs (in-dip) and slabs dipping in the same direction (same-dip). Where trenches converge over time (same-dip and out-dip systems), large positive dynamic pressures in the asthenosphere ...

We present the first study of the phase diagram of a thick film of superfluid He confined within a nanofabricated slab geometry. This cryogenic microfluidic chamber provides a well-defined environment for the superfluid, in which both the regular geometry and surface roughness may be fully characterised. The chamber is designed with a slab thickness d = 0.6 μm and 3 mm thick walls to allow pres...

S U M M A R Y Data from three seismic arrays installed in southern Peruwere analysed using receiver functions from P, PP and PKP wave phases, in order to image the subducted Nazca slab. The arrays cover the transition region from flat slab subduction in central Peru to normal subduction with an angle of about 30◦ further south. A previous study used data from the first array in the normal subdu...