The present study deals with the properties of five different metals/alloys (Al-12Si, Cu-10Sn and 316L—face centered cubic structure, CoCrMo and commercially pure Ti (CP-Ti)—hexagonal closed packed structure) fabricated by selective laser melting. The room temperature tensile properties of Al-12Si samples show good consistency in results within the experimental errors. Similar reproducible resu...

introduction: the aim of this study was to evaluate the morphological changes and quantitatively assess the roughness of dentin after the ablation with a ytterbium-doped potassium yttrium tungstate (yb: kyw) thin-disk femtosecond pulsed laser of different fluences, scanning speeds and scanning distances. method: twelve extracted human premolars were sectioned into crowns and roots along the cem...

Selective Laser Melting is an efficient process for producing metal parts with minimal subtractive post-processing required. Analysis of the parameters controlling the part quality has been performed focussing on the energy intensity during processing and the effect of the particle size distribution on factors such as ultimate tensile strength and surface finish. It is shown that the controllin...

The influence of laser processing parameters on mechanical properties and microstructure of pure titanium models made by selective laser melting is investigated. The density of the models can reach higher than 95% under proper conditions. Although the tensile strength test shows results comparable to the wrought material, the impact and torsional fatigue strengths are low because of porosity an...

the peak temperature in the sample was directly measured while the laser power was slowly increased. As soon as melting occurred in the hottest portion of the sample, the absorption increased drastically, leading to "runaway" melting and subsequent melting phenomena [figure 2B of (1)]. The melting temperatures we reported are the last temperatures of the solid before melting set in. We stated (...

Selective Laser Melting is an additive manufacturing technique, using a laser to promote the fusion followed by the solidification of a powder bed into a component. One of the most interesting topics about this process is the coalescence behavior of particles taking place in the powder bed during exposure. The coalescence of particles has been investigated in different fields of materials. Poly...

Fe-based amorphous alloys (FAA) have excellent anti-corrosion and anti-abrasive comprehensive performances. However, sprayed thin FAA coatings with high porosity cannot provide efficient protection, or even accelerate the corrosion rate of substrate due to galvanic corrosion. Laser re-melting densifying is usually used improve performance coatings. There are two disadvantages common laser metho...