A simple thermal-mechanical model for friction stir spot welding (FSSW) was developed to obtain similar weld performance for different weld tools. Use of the thermal-mechanical model and a combined approach enabled the design of weld tools for various sizes but similar qualities. Three weld tools for weld radii of 4, 5, and 6 mm were made to join 6061-T6 aluminum sheets. Performance evaluations...

To investigate the dominant factors that allow a reproducible nuclear reaction in DPd systems, the initial electric resistance and the hardness of the Pd cathode have been examined for excess heat generation and the excess neutron emission in LiOD-Pd electrolysis cells. Two background (control) runs and one foreground run with the Pd cathode of high electric resistance and high hardness gave no...

In this paper, we have investigated the combined effects of Newtonian heating and internal heat generation/absorption in the two-dimensional flow of Eyring-Powell fluid over a stretching surface. The governing non-linear analysis of partial differential equations is reduced into the ordinary differential equations using similarity transformations. The resulting problems are computed for both se...

in this paper, the amount of wasted heat from different parts of a 12 liter compression ignition engine and their potential for waste heat recovery were investigated. then, two-stage configuration of organic rankine cycle was introduced for simultaneous heat recovery from exhaust gases and coolant. finally, parameters like hybrid generated power, engine thermal efficiency and brake specific fue...

designing and optimization of the intake manifold is one of the important steps in the development of the internal combustion engines. in this paper, the flow inside the intake manifold of an internal combustion engine is investigated by numerical modeling. the convective flux models are adopted to simulate the unsteady compressible flow behavior. to solve the governing equations, for calculati...

-During the course of present investigation, effects of first order homogeneous chemical reaction and thermal radiation on two dimensional MHD flow of a visco-elastic fluid past a moving porous plate by considering double diffusive convection in presence of heat generation has been analyzed. A uniform magnetic field is applied in the direction normal to the moving plate. Also, the plate is cons...

In internal combustion engines, exhaust valve and its seat gain considerable temperature as the hot gases exit through them. So, the rate of heat transfer should be under control. In this study, the contact heat transfer coefficient has been estimated. An experimental study on an Air-Cooled internal combustion engine cylinder head has been considered. Using the measured temperatures of sensors ...

The combined effects of magnetic field, Navier slip and convective heating on the entropy generation in a flow of a viscous incompressible electrically conducting fluid between two infinite horizontal parallel plates under a constant pressure gradient have been examined. Both the lower and upper plates of the channel are subjected to asymmetric convective heat exchange with the ambient fluid. T...

In this research, the effects of parameters include tool rotational and traverse speeds were investigated on heat generation and material flow during friction stir welding of Ti-6Al-4V alloy with computational fluid dynamics (CFD) method. Simulation results showed that with increasing of tool rotational and decreasing tool traverse speed, the more frictional heat generates which causes formatio...

Two novel system configurations were proposed for oxy-fuel natural gas turbine systems with integrated steam reforming and CO2 capture and separation. The steam reforming heat is obtained from the available turbine exhaust heat, and the produced syngas is used as fuel with oxygen as the oxidizer. Internal combustion is used, which allows a very high heat input temperature. Moreover, the turbine...