Abstract: The microstructural features of the early stage of ordering of the intermetallic compound Pt2FeCu have been examined using optical and transmission electron microscopy in conjunction with X-ray diffraction technique. It was found that the compound has similar morphological alteration to that of FePt in which the ordering cannot be suppressed by rapid quenching. The early stage of ...

zinc coating is formed by the heterogeneous assembly of the γ, γ1, δ, ζ and η phases whose mechanicalproperties greatly differ from each other. thermal strains resulting from large differences betweenthermal expansion coefficients are partially relaxed by the formation of a crack network. in order tomodel this phenomenon, initial hardness, thermal expansion coefficient αi and toughness (kic) of...

A dedicated in situ heating setup a scanning electron microscope (SEM) followed by an ex atomic force microscopy (AFM) and backscatter diffraction (EBSD) is used to characterize the nucleation early growth stages of Fe-Al intermetallics (IMs) at 596 {\deg}C. location tracking interpret further characterization. Ex AFM observations reveal slight shrinkage out plane protrusion IM onset directiona...

AbstractIn this paper, we investigate effect of Fe–intermetallic compounds on plastic deformation of closed-cell composite Aluminum Foam as filler of thin-walled tubes. However, deformation of the Aluminum foam-filled thin-walled tubes as crushed-box will be presented in Part (II). Composite foams of AlSi7SiC3 and AlSi7SiC3-(Fe) as closed cell were synthesized by powder metallurgy foaming metho...

A method to produce nanoscale films of AuAlx and PtAlx, and their mesoporous elemental derivatives is described, and the morphology and optical properties of these coatings explored. The color of the AuAlx film is bright purple, in agreement with ab initio calculations and experimental observations for the compound AuAl2, but becomes black after de-alloying with NaOH. The film of PtAlx is silve...

In this work we compare the microstructures of intermetallic compounds (IMCs) in electrochemically stripped solder joints created by two different soldering methods (vapor phase soldering (VPS), and selective laser soldering with a CO2 laser). After the selective removal of the Sn phase with amperometry, the microstructure and structural composition of the IMC can be revealed in a detailed way,...

The elimination of the FexAly type phases was considered the solution to low ductility presented in aluminum-steel welded joints. Recently, the researches do not seek the suppression but the control of the thickness of these compounds. In this work, Al-Fe joints were manufactured by solid state and fusion welding, looking for controlling the formation of intermetallic comp...

the cold roll bonding of al on aisi 304l stainless steel was carried out to fabricate the al/304l/al clad sheet composites. the maximum bond strength of 20 n/mm was acquired just by 38% reduction, for which the tearing of the aluminum sheet occurred during the peeling test. the microstructural evolution during subsequent postannealing heat treatment was systematically studied based on the impur...

The influence of precipitation of intermetallics on changes in Young’s modulus of nickel and zirconium base alloys has been discussed in this paper. This study indicates that the change in the modulus due to thermal ageing in these alloys is essentially governed by the change in the modulus of the matrix due to removal of precipitation forming elements. 1.0 Introduction Mechanical properties in...

The growth behavior of intermetallic compounds (IMCs) at the liquid-solid interfaces in Cu/Sn/Cu interconnects during reflow at 250 °C and 280 °C on a hot plate was investigated. Being different from the symmetrical growth during isothermal aging, the interfacial IMCs showed clearly asymmetrical growth during reflow, i.e., the growth of Cu6Sn5 IMC at the cold end was significantly enhanced whil...