Squeeze Film Dampers (SFD) are commonly used for passive vibration control of rotor-bearing systems. The Magnetorheological (MR) and Electrorheological (ER) fluids in SFDs give a varying damping characteristic to the bearing that can provide active control schemes for the rotor-bearing system. A common way to model an MR bearing is implementing the Bingham plastic model. Adding this model to th...

This paper presents a new adaptive Sliding-Mode flux observer for speed sensorless and rotor flux control of three-phase induction motor (IM) drives. The motor drive is supplied by a three-level space vector modulation (SVM) inverter. Considering the three-phase IM Equations in a stator stationary two axis reference frame, using the partial feedback linearization control and Sliding-Mode (SM) c...

All single-rotor helicopters require an antitorque device (usually a tail-rotor system) to counter the fuselage’s reaction to the rotation of the main-rotor system. From 1988 through 1993, there were 74 U.S. civil turbine-engine helicopter accidents involving the helicopter’s tail-rotor system, according to statistics from the U.S. National Transportation Safety Board (NTSB) and the U.S. Federa...

Since many rotor systems normally operate above their critical speeds, the problem of accelerating the machine through its critical speeds without excessive vibration draws increasing attention. This paper provides an analytical imbalance response of the Jeffcott rotor under constant acceleration. The response consists of three parts: transient vibration due to the initial condition of the roto...

Direct torque control (DTC) of induction motors (IMs) requires an accurate knowledge on the amplitude and angular position of the controlled flux in addition to the information related to angular velocity for velocity control applications. However, unknown load torque and uncertainties related to stator/rotor resistances due to operating conditions constitute major challenges for the performanc...

The main advantage of tail-sitter unmanned aerial vehicle (UAV) are introduced. Three design solutions of rotor tailsitter lift system of UAV have been presented and the respective control strategies and characteristics of three solutions are also analyzed in the paper, through the related experiments the design of twin-rotor lift system is verified, and its feasibility is proved. The character...

An accurate and simpler approach for modelling and simulating the dynamic behavior of squirrel cage induction machines is presented here. The model is based on multiple coupled circuits and takes into account the geometry and winding layout of the machine. All inductances are derived by means of the winding function approach (WFA) and are integrated with the decomposition into their Fourier ser...

In order to have fault identification for the gate rotor shaft with multiple cracks effectively, the quantity identification method of the gate rotor shaft with multiple cracks based on wavelet finite element method is established and the frequency test of the gate rotor shaft based on blind source separation algorithm is analyzed. Firstly the wavelet finite element was established by combining...

This paper presents a means for reducing the torque variation during the revolution of a vertical-axis water turbine (VAWaterT) by increasing the blade number. For this purpose, twodimensional CFD analyses have been performed on a straight-bladed Darrieus-type rotor. After describing the computational model and the relative validation procedure, a complete campaign of simulations, based on full...

This paper presents a detailed study of the extended Kalman filter (EKF) for estimating the rotor resistance and rotor speed of an induction motor drive. The overall structure of the EKF is reviewed and the various system vectors and matrices are defined. By including the rotor resistance and rotor speed as a state variables, the EKF equations are established from a discrete two-axis model of t...