to investigate the hot deformation behavior of 17-7 ph stainless steel, hot compression tests were carried out at the temperatures of 950, 1050 and 1150 oc and strain rates of 0.001 s-1 to 0.1 s-1. accordingly, the hot working behavior was studied by the analyses of flow stress curves, work hardening rate versus stress curves, exponent- type constitutive equations and deformed microstructures. ...

The objective of this paper is to describe and analyze a series of nonlinear finite element analyses used to compare three design methods for locally slender, braced, steel beams and columns. The three design methods are: (i) the hot-rolled steel AISC Specification, (ii) the coldformed steel AISI Specification which uses the effective width method throughout, and (iii) the cold-formed steel Dir...

The hot deformation behavior of a typical martensitic stainless steel containing 2.1% Ni was investigated by means of the compression test in the strain rate range of 0.001-1 s-1 and temperature range of 950-1150 °C. The flow behavior of the steel was evaluated using the flow stress curves and flow softening map and by microstructural investigation. Taking into account of the strain effect on t...

With good mechanical properties and corrosion-resistance, galvanized coils are used in many fields nowadays, such as auto industry and household appliance industry. Because of high additional value of galvanized product, steel plants pay much more attention on how to make continuous galvanizing lines (CGL) run efficiently. In this paper, we address a scheduling problem of continuous galvanizing...

Low carbon ferritic steel alloyed with Ti, Mo and Cu was hot rolled and interrupt cooled to produce nano-sized precipitates of copper and (Ti,Mo)C carbides. The steel had a tensile strength of 840 MPa, an increase in yield strength of 380 MPa over that of the plain carbon steel and reasonable ductility. Transmission electron microscopy and small angle neutron scattering were used to characteriz...

The microstructure, mechanical properties, and hydrogen permeation behavior of hot rolled enamel steel were investigated. Three coiling temperatures were adopted to gain different sizes of ferrite grain and TiC precipitates. The results show that a large number of interphase precipitates of nano-sized TiC can be obtained at coiling temperatures of 650 and 700 °C, while a few precipitates are fo...

A duplex microstructure consisting of allotriomorphic ferrite and austenite at ambient temperature, has been produced in a low–alloy steel, by a simple heat treatment which involves intercritical annealing followed by quenching. The tensile properties obtained are good, with a total elongation of some 28% at an ultimate tensile strength approaching 900MPa. The form of the stress versus strain c...

Abstract Armco iron and L80 steel (according to API 5CT) were charged under various conditions due often not knowing the exact amount of hydrogen absorbed during operation laboratory charging. These two materials in sodium chloride (NaCl), sulfuric acid (H 2 SO 4 ), both with without addition thiourea (CH N S), H S (NACE TM0177) at open circuit potential. Additionally, cathodic charging was don...