The counting of fibres on membrane filters could be facilitated by using size-selective samplers to exclude coarse particulate and fibres that impede fibre counting. Furthermore, the use of thoracic size selection would also remove the present requirement to discriminate fibres by diameter during counting. However, before thoracic samplers become acceptable for sampling fibres, their performanc...

The present investigation was conducted on the low-speed impact response of quasi-isotropic [±45/0/90°]xs hybrid composite through laboratory level experimental tests. purpose to understand behaviour that different stacking sequences glass/carbon fibre composites has ability material sustain loads during events without developing critical structural failure in and improving energy absorption pr...

Surface properties of biomaterials play a major role in the governing of cell functionalities. It is well known that mechanical, chemical and nanotopographic cues, for example, influence cell proliferation and differentiation. Here, we present a novel coating protocol to produce hierarchically engineered fibrous scaffolds with tailorable surface characteristics, which mimic bone extracellular m...

Gecko-inspired microfibre arrays with 42 million polypropylene fibres cm(-2) (each fibre with elastic modulus 1 GPa, length 20 microm and diameter 0.6 microm) were fabricated and tested under pure shear loading conditions, after removing a preload of less than 0.1 N cm(-2). After sliding to engage fibres, 2 cm2 patches developed up to 4N of shear force with an estimated contact region of 0.44 c...

In this study three chemical agents Amino-propyl-triethoxy-silane (APS), sorbitol ended PLA oligomer (SPLA) and Hexamethylene diisocyanate (HDI) were identified to be used as coupling agents to react with the phosphate glass fibre (PGF) reinforcement and the polylactic acid (PLA) polymer matrix of the composite. Composites were prepared with short chopped strand fibres (l = 20 mm, ϕ = 20 µm) in...

Silicon is the second most common element on the Earth's crust and its oxide (SiO(2)) the most abundant mineral. Silica and silicates are widely used in medicine and industry as well as in micro- and nano-optics and electronics. However, the fabrication of glass fibres and components requires high temperature and non-physiological conditions, in contrast to biosilica structures in animals and p...

Improving the properties of fibre reinforced ceramics and glasses by optimizing their microstructure requires the knowledge of this structure down to the atomic level. In these materials energy-dissipative processes during fracture particularly act within an interface layer or layer system between fibre and matrix which can either be produced by fibre coating, or which develops during the proce...

We present THz time-domain spectroscopy measurements on glass-fibre reinforced polymers. The experimental set-up consists of a standard free-space THz spectrometer with photoconductive emitter and detector antennas driven by a femtosecond laser source. Single-point measurements to precisely obtain the THz properties of the sample are performed as well as two-dimensional images by scanning the s...

The distribution of length and diameter and the aspect ratio of crocidolite asbestos, a mineral substitute for asbestos (wollastonite), a manmade mineral fibre (glass wool), and synthetic fibres (polypropylene and polyacrylonitrite) were determined by light microscopy with phase contrast and, for crocidolite, also with transmission electron microscopy. The synthetic organic fibres and manmade m...

Tensile tests have been performed at up to five different displacement rates, from about lmm/s to over 20,000mm/s, on braided glass-fibre tubes of both square and circular cross-section and the corresponding force-displacement curves have been derived. In general both the maximum tensile force and the displacement at failure increase with increasing loading rate, implying a greater energy absor...