Electric power generation system development is reviewed with special attention to plant efficiency. While higher efficiency is well understood to be economically beneficial because of fuel savings, its effect upon reduction of all plant emissions without installation of additional environmental equipment, is less well appreciated. As CO2 emission control is gaining increasing acceptance,effici...

3-D migrations of time-lapse seismic monitor data acquired during steam injection show dramatic and complex changes in the reservoir zone over a wide area, compared to baseline seismic data recorded prior to steam injection. Anticipated large decreases in seismic P-wave velocity Vp near the injection well correlate with the presence of a hot desaturated steam zone. Unanticipated large increases...

The technical feasibility of using calcium oxide (CaO) as a sorbent for CO2 and Fe-Cr as a catalyst for the water-gas shift (WGS) reaction using syngas for the steam gasification of biomass was investigated. The effects of temperature, steam to biomass mass ratio, CaO to biomass molar ratio, and Fe-Cr WGS catalyst on gas composition were studied. Within a temperature range of 250 C to 550 C, ...

Introduction Gasifying biomass to produce a combustible gas provides the possibility for much more efficient overall conversion of a given biomass resource into electric power than is possible with traditional combustion-based technologies. In particular, gasified biomass can be used to power internal combustion engines (ICEs), gas turbines, and fuel cells, all of which are able to produce elec...

*Correspondence: J. N. Chung, Department of Mechanical and Aerospace Engineering, University of Florida, Gainesville, FL 32611, USA e-mail: [email protected] Two concept systems that are based on the thermochemical process of high temperature steam gasification of lignocellulosic biomass and municipal solid waste are introduced.The primary objectives of the concept systems are (1) to develop the ...

In March 2008, Keppel Seghers started the engineering, supply, construction and commissioning of a Combined Heat and Power (CHP) Waste-to-Energy (WtE) plant in Åmotfors (Sweden). When completed in 2010 the plant will process close to 74,000 tons per year of household waste (average LHV = 10.5 MJ/kg) and limited quantities of (demolition) wood resulting in a yearly production of about 108,700 MW...

An increase in fossil fuel consumption has significantly increased the concentration of greenhouse gases (GHGs). Waste energy recovery can reduce GHGs by reducing fossil fuel consumption. In the FCC unit in refineries, the catalyst is continuously regenerated by burning off the deposited coke with air and a large flux of waste gas with high temperature is generated which is vented into the atmo...

The efficiency of the application of high-emissivity coatings on the furnace walls in steam cracking technology can only be evaluated on the asis of a description of radiative heat transfer distinguishing between the frequency bands. To this end, a non-grey gas radiation model based on he exponential wide band model (EWBM) has been developed and applied in the context of three-dimensional CFD s...

Large-scale U.S. dependence on thermoelectric (steam electric) generation requiring water for cooling underscores the need to understand controls on this water use. The study objective was to quantify water consumption and withdrawal for thermoelectric generation, identifying controls, using Texas as a case study. Water consumption for thermoelectricity in Texas in 2010 totaled ∼0.43 million ac...