In this paper, the corrosion residual strength of the AZ91D magnesium alloy in the presence of sulfate-reducing bacteria is studied. In the experiments, the chemical composition of corrosion film was analyzed by a scanning electron microscope with energy dispersive X-ray spectroscopy. In addition, a series of instruments, such as scanning electronic microscope, pH-meter and an AG-10TA materials...

Thin film metallic glasses comprised of Zr48Cu36Al8Ag8 (at.%) of approximately 1.5 μm and 3 μm in thickness were prepared using magnetron sputtering onto medical grade 316L stainless steel. Their structural and mechanical properties, in vitro corrosion, and antimicrobial activity were analyzed. The amorphous thin film metallic glasses consisted of a single glassy phase, with an absence of any d...

There are a number of ways to improve the corrosion and abrasion resistance of metals, including alloying, anodizing, nitriding and application of protective thin films. Alloying involves generating a binary phase diagram to determine the optimum composition and temperature dependence. For example, copper alloys known as “bronzes” offer high strength, abrasion resistance and high temperature co...

The influence of potential on contact angle and the effect of TPB width on the cathodic corrosion processes of metals were studied by steady polarization and EIS technique combined with contact angle measurement. It is found that both cathodic limiting current density and corrosion current density linearly increases with increasing the TPB width, confirming the important role of TPB width in ga...

The corrosion behavior of 2A02 Al alloy under 4 mg/cm² NaCl deposition at different temperatures (from 30 to 80 °C) has been studied. This corrosion behavior was researched using mass-gain, scanning electron microscopy-SEM, laser scanning confocal microscopy-LSCM, X-ray photoelectron spectroscopy-XPS and other techniques. The results showed and revealed that the corrosion was maximal at 60 °C a...

Abstract A salt spray test was used to evaluate the corrosion resistance of pickling high-strength steel JSH440W phosphating film on its surface, and scanning electron microscope (SEM) energy dispersive spectrometer (EDS) were analyze micro-morphology element content surface defects area sample after test. The results show that enrichment Si, Mn, O elements badly influences film-forming perform...

This document covers recommended practice for the radiographic inspection of corrosion in small bore piping and in the small bore connections to larger diameter main pipes. Inspection of this type of component is not covered by any internationally recognised standards or procedures, and there is therefore a need for guidance on recommended practice. Recommendations are given concerning techniqu...

In this study, the bio-electrochemical response of the Ti–Zr–Si thin film metallic glasses (TFMGs) in simulated body fluid with different contents of titanium is measured via potentiostat. According to the results of bio-corrosion potential and current, as well as the polarization resistance, it is concluded that the Ti66Zr25Si9 TFMGs possess the highest bio-electrochemical resistance. With inc...

--The inhibition of the corrosion of mild steel in hydrochloric acid solutions by the extract of Artemisia Herba-Alba has been studied using gravimetric and electrochemical measurement. Inhibition was found to increase with increasing concentration of the inhibitor. Values of inhibition efficiency calculated from weight loss and potentiodynamic polarization are in good agreement. This value goe...

The corrosion inhibition and adsorption (CIA) performance of the aqueous extracts of Aaronsohnia pubescens aerial parts (Odorized aqueous extract (OE) and Deodorized aqueous extract (DE)) on the corrosion mild steel (MS) in 1M hydrochloric acid were evaluated. It is based on the weight loss (WL) analysis, kinetic and thermodynamic parameters, and electrochemical methods both stationary (Potenti...