Nickel is an essential engineering material and electrodeposited Ni has been widely used in many fields to improve surface finishing, corrosion resistance and wear properties. The kinetics of electrochemical deposition of nickel from chloride baths in the presence and absence of saccharin on the copper substrate was investigated by applying cyclic voltammetry and chronoamperometry measureme...

Surfaces of boron carbide (B4C) were implanted with 200 keV N: or 100 keV AI + ions to a dose of 8 x 10” cm‘. Ultralow load indentation via the Nanoindenter was used to determine the changes in surface hardness and elastic modulus following implantation. A pin-on-disk testing device in ultrahigh vacuum was used for measuring changes in friction and wear of the implanted disks. Results of hardne...

We examined the correlation of wear effects with dielectric properties of carbon nanofibers (CNFs; untreated and organosilane-treated)-reinforced high-density polyethylene (HDPE) composites. Wear testing for the nanocomposites over up to 120 h was carried out, and then, dielectric permittivity and dielectric loss factor of the polymer composites with the increased wear time were studied. Scanni...

ni-hard4 white cast iron is excellent wear resistant material and has been widely used in wearaffected equipment operated under extreme conditions, such as in mineral processing, cement, copper and iron manufacturing. in this study the effect of titanium addition (1.2, 0.7 and 0.2 wt.%) to the ni-hard 4 cast iron with the nominal composition of si= 1.5%, mn=0.5%, c=3%, p=0.05%, s= 0.05%, mo= 0....

The optoelectronic properties of gallium nitride (GaN) have been well studied for decades, with results being translated to applications in solid state lighting and lasers, thermoelectricity, solar cells, power electronics, etc. However, the mechanical and tribological properties of GaN have been studied and understood far less than its optoelectronic properties. Our research aims to explore th...

Nowadays the surface texturing has been widely recognized as a usable capability to improve the tribological systems. In this paper, ultrasonic assisted turning (UAT) isperformed to create the micro textures on the flat faces. Micro surface texturing ismade on the Al7075-T6 by the UAT in the face turning process. Then, the influences of cutting speed feed, vibration direction and vibration ampl...

aisi 304l austenitic stainless steel with different grain sizes of 0.5 -12 μm was obtained through the martensiticprocess. corrosion behavior of different samples was investigated in a 0.5m hcl solution using open circuitpotential, potentiodynamic polarization and electrochemical impedance spectroscopy tests. also, the correlationbetween the grain size and pitting corrosion resistance was asses...

A new Stratified Approach For Enhanced Reliability (SAFER) pre-clinical simulation testing of joint prostheses has been described in a preceding paper in this volume. The application of SAFER in vitro simulation and testing to metal-on-metal bearings is described in this review paper. The review aims to provide further understanding of the reasons for, and causes of, increased wear in metal-on-...

Nowadays the surface texturing has been widely recognized as a usable capability to improve the tribological systems. In this paper, ultrasonic assisted turning (UAT) isperformed to create the micro textures on the flat faces. Micro surface texturing ismade on the Al7075-T6 by the UAT in the face turning process. Then, the influences of cutting speed feed, vibration direction and vibration ampl...