The series–parallel resonant converter (also called line level control (LLC) resonant converter) is one of the most suitable topologies for dc–dc power supply. This study introduces the LLC resonant converter into the on-board battery chargers for the plug-in hybrid electric vehicle (PHEV) applications. Different from the previous literature which has focused on the wide operation range and hol...

Abstract: In this paper a new topology of high step-down dc-dc converter is proposed. The proposed converter uses an interleaved structure with one phase using a traditional buck converter and the second phase uses its inverted version. By this technique a high step down voltage conversion can be achieved as compared to the traditional interleaved buck converter. Operating principle and steady ...

— The design of an efficient monolithic buck converter is presented in this paper. A low swing MOSFET gate drive technique is proposed that improves the efficiency characteristics of a DC-DC converter. A model of the parasitic impedances of a buck converter is developed. With this model, a design space is described which characterizes the integration of both active and passive devices of a buck...

This paper presents the modeling and simulation of a proton exchange membrane fuel cell (PEMFC) generation system for off-grid and on-grid operation and configuration. A fuel cell DG system consists of a fuel cell power plant, a DC/DC converter and a DC/AC inverter. The dynamic model for fuel cell array and its power electronic interfacing are presented also a multi-input single output (MISO) D...

Current-mode control (CMC) is an extremely popular dc-dc converter loop architecture—and with good reason. Simple operation and dynamics are achieved even though two loops, a wide-bandwidth current loop lurking inside an outer voltage loop, are required. Peak, valley, average, hysteretic, constant on-time, constant offtime, and emulated current-mode are commonly used. Each technique offers plus...

The purpose of this paper is twofold. On one hand, basics on switched circuits for designing a DC-DC converter are presented and, on the other hand, power electronics definitions associated with simple electrical networks are mentioned. In the analysis of these networks, it is necessary to take into account not only converters’ non-idealities but also how to minimize power losses. Since power l...

p.1

The purpose of this project was the modeling, optimization and prediction of a hybrid system composed of a fuel cell, a dc-dc converter and a supercapacitor in series. Lab tests were performed for each device to understand their behavior, and then each one was modeled using software (Simulink). The validation of the model was done by comparing its results with measured data; finally the model w...

The last few years, a considerable number of studies have been made on a digital control. One reason is that this technique will lead to a future energy management and system integration. At a first step, it may be helpful to begin with a study of the design criterion of the digital control. Although studies have been made on the digital unique characteristics, there is little agreement on the ...

Stable inversion plays a key role in the solution of the exact tracking control problem in nonminimum phase systems. However, the general methods developed so far for the computation of stable inverses require backwards time numeric integration of the internal dynamics equation, which yields high sensitivity to external disturbances and/or structured uncertainties. This article introduces an it...