In this paper, a coplanar waveguide (CPW)-fed dual-band slot antenna with circular polarization (CP) is presented. In order to achieve CP characteristic, an asymmetric slot and F-shaped end patch are introduced to a conventional rectangular slot antenna. Moreover, by cutting a T-shaped notch on the ground plane, the axial ratio (AR) bandwidth (ARBW) can be extended. The antenna shows left-hand ...

Experimental study on slicing of sapphire with fixed abrasive diamond wire saw was conducted in this paper. The process parameters were optimized through orthogonal experiment of three factors and four levels. The effects of wire speed, feed speed and tension pressure on the surface roughness were analyzed. Surface roughness in cutting direction and feed direction were both detected. The result...

Numerical models based on linear elasticity theory predict asymmetric slip distribution with a steep slip gradient near the line of intersection of intersecting normal faults. They also predict a discrepancy between the direction of slip on the fault plane and the direction of resolved shear stress. Both variations in slip magnitude and direction are due to mechanical interaction between the fa...

Abstract The paper reports experimental research on torques during cardboard cutting in the die-cutting press with eccentrics drive of movable pressure plate. To conduct research, an bench is designed and manufactured. manufactured device for blanks provides possibility getting dependencies loadings at different parameters process. approach envisages use strain gauge measurement method wireless...

The aim of this work is the investigation mesoscale/local variability in mechanical properties clear timber radial direction. Clear Norway spruce wood, Picea abies, was used for cutting specimens different lengths with a small cross-sectional area 4 × mm2, direction boards, and tested under tensile loading. In some were positioned regularly and, others, randomly, local deformations each specime...

Temperature control during the cutting process with different parameters such as cutting velocity and applying water cooling is essential to decrease the cutting force, increase the life of the cutting tool and decrease the machined surface temperature of work-piece. In this research, the temperature of machined surface and the chip-tool interface in orthogonal cutting process of Ti-6Al-4V were...

In order to study the blasting effect and damage rock mass when cutting seam cartridge is eccentrically uncoupled. The ANSYS/LS-DYNA® nonlinear dynamic platform was used simulate of five eccentric uncoupled coefficients on cartridge, crack growth process under condition complete eccentricity simulated. By comparing analyzing stress measuring points in direction seam, vertical direction, circumf...

to assessment alfalfa cultivars research project this research has been fulfilled in 2011 at khouzestan agricultural and natural resource research center in southwest of ahwaz in khouzestan province (iran) by position 31º20′ n, 48º40′ e. at first section for evaluation wet forage yield cultivars such as “baghdadi”, “mesasersa”, “yazdi”, “bami”, “nikshahri”, “synthetic” (main factor) and two cut...

An instantaneous rigid force model for prediction of cutting forces in ball-end milling of  sculptured surfaces is presented in this paper. A commercially available geometric engine is used to represent the cutting edge, cutter and updated part geometries. The cutter used in this work is an insert type ball-end mill. Intersecting an inclined plane with the cutter ball nose generates the cutting...

When a blunt cutting tool is forced through a thin elastic sheet that is held along its lateral boundaries, a strikingly regular wavy cut can be left behind, examples of which are presented in Fig. 1. The thin film is brittle, hence it undergoes negligible irreversible deformation besides fracture. For tools much wider than the film’s thickness, the crack tip follows a highly reproducible nonsi...