Nanosized CuO-CeO2, CuO-Fe2O3, CuO-CeO2-Al2O3 and CuO-Fe2O3-CeO2-Al2O3 were prepared by co-precipitation and wet impregnation techniques and were used for Catalytic decomposition of acetylene to produce carbon nanotubes (CNTs). Weight gain technique was used to follow up the catalytic reactions. The results revealed that catalyst chemical composition, catalytic temperature, acetylene flow rate ...

We report studies of exchange bias and coercivity in ferromagnetic Ni81Fe19 layers coupled to antiferromagnetic (AF) (0001), (112̄0), and (110̄2) α-Fe2O3 layers. We show that AF spin configurations which permit spin-flop coupling give rise to a strong uniaxial anisotropy and hence a large coercivity, and that by annealing in magnetic fields parallel to specific directions in the AF we can control...

Extensive use of nanoparticles (NPs) in consumer and industrial products has led to concerns about their potential environmental impacts; however, the influences of different NPs (e.g., nZVI (nano zero-valent iron), Ag NPs, Fe2O3 NPs and MgO NPs) on the anaerobic digestion of sludge have not yet been studied in depth. Additionally, a new guideline or the use of different NPs in the anaerobic di...

The existing forms of Fe are of great interest since they have a profound effect on the biological availability of Fe. In this work, aerosol samples collected in different seasons and at different locations in the Qingdao region were examined by means of extended X-ray absorption fine structure (EXAFS) K-edge analysis of Fe, X-ray diffraction (XRD) and Fe content analysis. The results showed th...

We reported a facile adjusted method for the synthesis of high surface area nanorod hematite film as a photoanode for application in water splitting. Crystalline hematite nanorods (EG-α-Fe2O3) are fabricated by electrodeposition in Fe(2+) precursor solution with the addition of ethylene glycol (EG) and followed by annealing at 450 °C. The nanorod hematite film fabricated by the modified electro...

We have previously shown that 1-hr exposures to 0.5 microns sulfuric acid (H2SO4) mist at 100 and 1000 micrograms/m3 produced transient alterations of bronchial mucociliary clearance of monodispersed 7.6 and 4.2 microns mass median aerodynamic diameter gamma-tagged ferric oxide (Fe2O3) in healthy nonsmoking humans in a dose-dependent manner. To determine the role, if any, of the length of expos...

Intrinsic doping of hematite through the inclusion of oxygen vacancies (VO) is being increasingly explored as a simple, low temperature route to preparing active water splitting α-Fe2O3-x photoelectrodes. Whilst it is widely accepted that the introduction of VO leads to improved conductivities, little else is verified regarding the actual mechanism of enhancement. Here we employ transient absor...

In this study, we constructed an inverse opal structured hematite (IOS α-Fe2O3) as the photoanode of a photoelectrochemical (PEC) cell for efficient solar water splitting via a simple electrochemical process. At the same time, a series of affecting factors (template particle size, electrodeposition time and annealing temperature) to construct the IOS α-Fe2O3 photoanode on the photoelectrochemic...

A series of tellurite glasses containing Fe2O3 with the nominal composition x(Fe2O3)–(1 x)(TeO2), where x = 0.05, 0.10, 0.15, and 0.20, have been synthesized and investigated using X-ray photoelectron spectroscopy (XPS) and magnetization techniques. The Te3d core level spectra for all glass samples show symmetrical peaks at essentially the same binding energies as measured for TeO2 indicating t...

Electrocatalysts improve the efficiency of light-absorbing semiconductor photoanodes driving the oxygen evolution reaction, but the precise function(s) of the electrocatalysts remains unclear. We directly measure, for the first time, the interface carrier transport properties of a prototypical visible-light-absorbing semiconductor, α-Fe2O3, in contact with one of the fastest known water oxidati...