Thermal convection in the Antarctic and Greenland ice sheets has been dismissed on the grounds that radio-echo stratigraphy is undisturbed for long distances. However, the undisturbed stratigraphy lies, for the most part, above the density inversion in polar ice sheets and therefore does not disprove convection. An echo-free zone is widespread below the density inversion, yet nobody has cited t...

Directionally-solidified (DS) Ni-base superalloys are commonly applied as turbine materials to primarily withstand creep conditions manifested in either marine-, airor landbased gas turbines components. The thrust for increased efficiency of these systems, however, translates into the need for these materials to exhibit considerable strength and temperature resistance. Accurate prediction of cr...

The creep behavior of nanocellulose films and aerogels are studied in a dynamic moisture environment, which is crucial to their performance in packaging applications. For these materials, the creep rate under cyclic humidity conditions exceeds any constant humidity creep rate within the cycling range, a phenomenon known as mechanosorptive creep. By varying the sample thickness and relative humi...

Stimulated by the excessive deflections and collapse of the KB Bridge of world-rercord span, the deflection histories of 56 similar bridges, most of them excessive, have been collected by RILEM TC-MDC. They amount to a wake-up call: The standard creep recommendations of engineering societies have been misleading, and thus their revision is imperative. They also confirm a simple feature: The mul...

The correct choice of a material in the process of structural design is the most important task. This study deals with determining and analyzing the mechanical properties of the material, and the material resistance to short-time creep and fatigue. The material under consideration in this investigation is austenitic stainless steel X6CrNiTi18-10. The results presenting ultimate tensile strength...

In this article, experimental results on the effect of CO2 sorption and desorption on the creep response of polycarbonate (PC) are presented. Tensile specimens machined from PC sheets were exposed to CO2 and the absorbed gas mass fraction ranged from 0.045 to 0.12. The creep/creep recovery response of as-received PC, saturated PC, and saturation-cycled PC was characterized. It was found that th...

To capture the mechanical response of Ni-based materials, creep deformation and rupture experiments are typically performed. Long term tests, mimicking service conditions at 10,000 h or more, are generally avoided due to expense. Phenomenological models such as the classical Kachanov–Rabotnov (Rabotnov, 1969, Creep Problems in Structural Members, North-Holland, Amsterdam; Kachanov, 1958, “Time ...

The short and long term creep behavior is one of the most important properties of polymers used for engineering applications. In order to study this kind of behavior of PP tensile and short term creep measurements were performed and analyzed using long term creep behavior estimating method based on short term tensile and creep tests performed at room temperature, viscoelastic behavior, and vari...

In this study, a novel multiscale combined creep strain and creep rupture model is proposed. By comparing to experimental data it was shown that the model provides accurate creep rupture predictions for unidirectional off-axis specimens. The creep strain model provides accurate predictions within the confines of the linear elastic restrictions used in its development. This creep strain and cree...

OBJECTIVES To evaluate the viscoelastic properties of demineralized dentin matrix. Stress-relaxation studies were done on matrices in tension and strain elongation or creep studies were done in both tension and compression. METHODS Mid-coronal dentin disks were prepared from extracted unerupted human third molars. Disks were 0.5 mm thick for stress-relaxation or tensile creep experiments and ...