Abstract The Crofer 22 H ferritic steel substrate was coated with an Mn 1.45 Co Cu 0.1 O 4 spinel by means of electrophoresis. After high-temperature oxidation under thermal cycling conditions, the physicochemical properties obtained system were evaluated. During 48-h cycles that involved heating samples up to temperatures either 750 or 800 °C, kinetics both and unmodified approximately obeyed ...

ni-w coatings, compared to pure nanocrystalline ni, exhibit higher hardness and wear resistance. in some cases, these coatings are considered as environmental friendly alternatives for hard chromium coating. till now, most of ni-w coatings have been produced by direct current electrodeposition from alkaline baths. in this study square pulse current was used for deposition of ni-w precipitates f...

The sensor characteristics of a coated Fiber Bragg grating (FBG) thermal sensor for cryogenic temperatures depends mainly on the coating materials. The sensitivity of the coated FBG can be improved by enhancing the effective thermal strain transfer between the different layers and the bare FBG. The dual coated FBG’s has a primary layer and the secondary layer. The primary coating acts as an int...

This paper compares different coating methods (in situ solid combustion, hybrid deposition, secondary growth on seed, suspension, double deposition of wet impregnation and suspension) to deposit Ce0.2Zr0.8O₂ mixed oxides on cordierite substrates, for use as a three way catalyst. Among them, the double deposition was proven to be the most efficient one. The coated sample shows a BET (Brunauer-Em...

In this study, the hot corrosion of TiAl, TiAlNb, and Ti3AlNb intermetallics with or without enamel coating and sputtered TiAlCr coating in (Na, K)2SO4 + NaCl melts at 750oC is investigated. The interfacial reaction between enamel and those alloys during hot corrosion has also been evaluated. The results indicate that severe corrosion of bare alloys occurs due to the self catalysis chlorination...

Uniform nanostructure coating of TiO2 was prepared on 316L stainless steel by sol-gel method using Tetra-n-Butyle Titanat (TBT) as alkoxide material. 316L specimens were coated with the mentioned sol by dip coating method. The influences of preparation condition, pH of sol on TiO2 nanostructure coating were investigated. Their structural properties were examined at var...