نتایج جستجو برای: coulomb criterion

تعداد نتایج: 91913  

Journal: :journal of modern processes in manufacturing and production 0
reza nosouhi modern manufacturing technologies research center, najafabad branch, islamic azad university, najafabad, iran saeed behbahani department of mechanical engineering, isfahan university of technology, isfahan, iran saeid amini manufacturing department, faculty of engineering, university of kashan, kashan, iran mohammad reza khosrojerdi manufacturing department, faculty of engineering, university of kashan, kashan, iran

a new dynamic friction model for modeling of elliptical vibration assisted turning (evat) was developed in this research. the periodic change of the friction force direction is known to be one of the most important causes of this phenomenon. in modeling of machining processes (including the evat process), static coulomb friction model was employed by most of the researchers. because of the peri...

Journal: :Journal of Petroleum Exploration and Production Technology 2021

Abstract Given the complexities of reservoir exploration and development, it is vital to understand geomechanical properties well in drilling operation. In constructing a mechanical model earth, combination environmental parameters, as magnitude direction stresses, used. this study, stress analysis its effect on azimuth deviated an oil field located southwestern Iran are investigated. Necessary...

Dynamic compaction is a soil improvement method which has been widely used for the increase of bearing capacity through stress wave propagation during heavy tamping. The cost and time of project implementation can be effectively curtailed by developing a model that can be used in the design of dynamic compaction operations. The numerical models offered so far are mostly one or two-dimensional, ...

In the current paper the results of a numerical simulation that were verified by a well instrumented experimental procedure for studying the arching effect over a trapdoor in sand is presented. To simulate this phenomenon with continuum mechanics, the experimental procedure is modeled in ABAQUS code using stress dependent hardening in elastic state and plastic strain dependent frictional harden...

2008
J. D. Zhao A. V. Lyamin S. W. Sloan

ABSTRACT: In this paper, shakedown limits of non-homogeneous soils in a half-space under rolling and sliding surface loads are investigated. The inhomogeneity of the soil is described by a power law for the variation of Young’s modulus with the depth. Mohr-Coulomb criterion is employed to characterise the cohesive-frictional behaviour of the soil. Analytical solutions to the elastic stress fiel...

2010
F. Froiio J.-N. Roux

We systematically investigate the incremental response of various equilibrium states of dense 2D model granular materials, along the biaxial compression path (σ11 < σ22, σ12 = 0). Stress increments are applied in arbitrary directions in 3dimensional stress space (σ11,σ22,σ12). In states with stable contact networks we compute the stiffness matrix and the elastic moduli, and separate elastic and...

1997
Motoi Tachibana

We investigate the phase structures of various N = 1 supersymmetric gauge theories including even the exceptional gauge group from the viewpoint of superconvergence of the gauge field propagator. Especially we analyze in detail whether a new type of duality recently discovered by Oehme in SU(Nc) gauge theory coupled to fundamental matter fields can be found in more general gauge theories with m...

2014
Qunyi Liu Wanli Xing Ying Li

The joint surface is widely distributed in the rock, thus leading to the nonlinear characteristics of rock mass strength and limiting the effectiveness of the linear model in reflecting characteristics. The JRC/JCS model is the nonlinear failure criterion and generally believed to describe the characteristics of joints better than other models. In order to develop the numerical program for JRC/...

Journal: :journal of nanostructures 2012
p. sadeghi-alavijeh m. monemzadeh n. tazimi

in this paper, using monte carlo fortran code, we have obtained the binding energies for three different systems of diquark–antidiquark in distances from 0.01 to 15 nm. in [0.1 - 15] nm interval, we made use of coulomb potential because in this interval, strong interaction is negligible. we have compared the binding energies of the systems with one another. the results of these comparisons were...

2008
Gordon Baym Peter Braun-Munzinger

We discuss the elementary physics of the final state Coulomb interactions in HanburyBrown Twiss interferometry, showing – with explicit comparison to E877 data for π+π− and π±p – that the Coulomb corrections in the pair correlation function can be well understood in terms of simple classical physics. We connect the classical picture with descriptions in terms of Coulomb wave functions, and inve...

نمودار تعداد نتایج جستجو در هر سال

با کلیک روی نمودار نتایج را به سال انتشار فیلتر کنید