The aim of this paper is presentation of an approach for modeling , control and optimization of a photovoltaic pumping system which contains a PV generator , DC-DC boost converter, MPPT controller, DC-AC inverter and a BLDC motor. We use an intelligent control method for searching the maximum power point (MPP). This method uses a fuzzy logic controller applied to a drive a DC–DC converter to an...

A brushless DC motor with integrated drive circuit for air management system is presented. Using magnetic equivalent circuit model a basic design of the motor is determined, and specific configurations are inspected thanks to finite element analysis. In order to reduce an unbalanced magnetic force in an axial direction, induced forces between a stator core and a permanent magnet are calculated ...

Compared to the proportional-integral strategy, repetitive control strategy possesses high suppression ability for alternating current (AC) harmonics of signals. Thus, RC controllers are widely used in closed-loop systems suppress periodic harmonics. In order further improve brushless DC (BLDC) motor operation performance, a frequency adaptive controller (FARC) is proposed, and then novel loop ...

-This paper Discuss about the problem occurring in the medium voltage distribution network such problems reactive power, harmonics and unbalanced load current compensation of Medium voltage Distribution systems. It proposes a simple and inexpensive solution to enhance power quality when a particular connection to the high voltage transmission network. It presents the design of a active power fi...

This paper describes a method for reducing the common-mode voltage in seven-phase brushless DC motor (BLDC) drive. The conventional interleaved used three-phase inverter system is extended and applied. proposed phase-phase studied to apply six-phase excitation controlling BLDC. switching functions related with modulation index (MI) angle are obtained, average of derived mathematically. control ...

This paper uses a new position sensor less drive for brushless DC (BLDC) motors. In conventional sensor less control methods such as the back-EMF detection method, the performance is high only at a high speed range due to the fact that the magnitude of the back-EMF is dependent on the rotor speed. A solution is derived that estimates the rotor position by using an unknown input observer over a ...

The paper gives design methods dedicated to speed control of Direct Current (DC) and Brushless Direct Current (BLDC) motors in the framework of servo systems. Two design approaches are offered for position and speed control of servo systems with inner current control loops. The PI and PID controllers in these approaches are tuned on the basis the Extended Symmetrical Optimum method and of the d...

This paper provides a technical review of position and speed sensorless methods for controlling Brushless Direct Current (BLDC) motor drives, including the background analysis using sensors, limitations and advances. The performance and reliability of BLDC motor drivers have been improved because the conventional control and sensing techniques have been improved through sensorless technology. T...

This paper deals with the Direct Torque Control (DTC) of Brushless DC (BLDC) motor drives fed by four-switch inverters (also known as B4inverters) rather than six-switch inverters (also known as B6 inverters) in conventional drives. The principle of operation of the BLDC motor is firstly recalled considering both cases of B6and B4-inverters in the armature, with emphasis on the twoand three-pha...