The potential of Palm Methyl Esters (PME) as an alternative fuel for gas turbines is investigated using a swirl burner. The main air flow is preheated to 623 K and a swirling spray flame is established at atmospheric pressure. The spray combustion characteristics of PME are compared to diesel and Jet-A1 fuel under the same burner power output of 6 kW. Investigation of the fuel atomizing charact...

This paper presents results of an empirical study on the flow and noise generated by the trailing edge of a flat plate encountering low turbulence fluid flow. Simultaneous measurements of flow and far-field noise data have been taken in an anechoic wind tunnel at the University of Adelaide. Velocity data about the trailing edge and in the wake have been measured using hot-wire anemometry. These...

Accurate calibration is imperative to obtain reliable flow measurements using hot-wire anemometry. Calibration errors owing to temperature drift, wire degradation, changes in ambient conditions etc can lead to substantial uncertainties in hot-wire measurements. A new calibration procedure is implemented here to account for most forms of drift that are typically encountered during high quality f...

In their recent topical review, Nabavi and Siddiqui (Meas. Sci. Technol. 2010 21 042002) recommended the use of hot-wire anemometry for velocity measurements in pulsating flows, especially at high frequency. This recommendation is misleading. The procedures invoked by these authors are valid only for small-amplitude fluctuations, which are of little interest for pulsating flows. When large-ampl...

The frequency spectrum of angle-of-arrival (AOA) fluctuations of optical waves propagating through atmospheric turbulence carries information of wind speed transverse to the propagation path. We present the retrievals of the transverse wind speed, upsilon b, from the AOA spectra measured with a Schmidt-Cassegrain telescope equipped with a CCD camera by estimating the "knee frequency," the inter...

Diameter, velocity, and charge measurements of progeny droplets produced in-flight by a millimeter-size parent drop subjected to electric and ionic fields are reported. Different drop breakup modes were studied using phase doppler anemometry and high-speed digital photography. Drop breakup occurred in applied electric (∼1 kV/cm to ∼10 kV/cm) and ionic (∼10(13)/m(3) to ∼10(15)/m(3)) fields that ...

We present the dynamic velocity profiles of a Newtonian fluid (glycerol) and a viscoelastic Maxwell fluid (CPyCl-NaSal in water) driven by an oscillating pressure gradient in a vertical cylindrical pipe. The frequency range explored has been chosen to include the first three resonance peaks of the dynamic permeability of the viscoelastic-fluid--pipe system. Three different optical measurement t...

Measurements and numericaL calculations of laminar flow in a plane 90 degrees bifurcation are presented. The corresponding two-dimensional steady flow Navier-Stokes equations solved by a finite-difference procedure employing pressure and velocity as dependent variables. The influence of Reynolds number and mass flow ratio on the velocity field, streamlines, local shear stress and pressure drop ...

This Letter presents an all-optical high-temperature flow sensor based on hot-wire anemometry. High-attenuation fibers (HAFs) were used as the heating elements. High-temperature-stable regenerated fiber Bragg gratings were inscribed in HAFs and in standard telecom fibers as temperature sensors. Using in-fiber light as both the heating power source and the interrogation light source, regenerativ...

The prediction of droplets diameter and velocity distribution in a spray is so difficult since its process and mechanism is not completely known and depends too many parameters. The early stage of the atomization process (Primary Breakup) is clearly deterministic, whereas the final stage of spray formation (Secondary Breakup) is random and stochastic. In the second region, which deals with the ...