This article reports positron annihilation spectroscopy and calorimetric measurements of the aging behavior in a Cu–Al–Be shape memory alloy. An excess of single vacancies is retained in the alloy as a result of a quench. All vacancies in excess disappear after long aging time, and a migration energy EM51.060.1 eV for this process has been found to be larger than in other Cu-based shape memory ...

COST reduction is a key objective of modern airframe The 7449 and 7150 plates, respectively 30and 36-mm manufacture. This can be achieved by the design of materials thick, were provided by Pechiney CRV (Voreppe, France) with improved properties leading to weight reduction of the in a solutionized, quenched, and stretched condition (corresairframe structure and, therefore, reduction in fuel cons...

This study presents the application of the finite element method and intelligent systems techniques to the prediction of microstructural mapping for aluminium alloys. Here, the material within each finite element is defined using a hybrid model. The hybrid model is based on neuro-fuzzy and physically based components and it has been combined with the finite element technique. The model simulate...

The single crystal Cu-Al-Ni alloys became generally commercialized. It can be observed that response time of any single crystal Cu-Al-Ni-based shape memory alloy (SMA) actuator is greater than the necessary when it is used for human prosthesis. Moreover, the electrical SMA actuator type with better performance than the thermal one is very problematic for this type of crystal due to its low elec...

In this study, the elemental powders of aluminum and copper were initially subjected to mechanical alloying using an attrition ball mill under argon atmosphere to produce an Al-4.5 wt% Cu powder alloy. The WC nanoparticles were then added to the powder alloy and milled in a planetary ball mill to explore the role of the WC nanoparticles on the mechanical properties of the fabricated composite p...

 Microsegregation is one of the most important phenomena occurs during solidification. It usually results in formation of some unexpected second phases which generally affect the mechanical properties and specially reduce the workability of casting products. The aim of this research is to study the effect of cooling rate and grain refinement on the microsegregation in Al-4.8 wt.% Cu. For this p...

the full annealing aa6061 aluminum alloy was subjected to severe plastic deformationvia the combination of equal channel angular pressing (ecap) and cold rolling (cr) in order torefine its microstructure and to improve its mechanical properties. according to the results of hotand cold tensile tests, the combination of ecap and cr significantly affected the final strengthand ductility of studied...

The hot deformation and dynamic recrystallization behavior of the dual-phase Mg-9Li-3Al-2Sr-2Y alloy had been investigated using a compression test. The typical dual-phase structure was observed, and average of grain size of as-homogenized alloy is about 110 µm. It mainly contains β-Li, α-Mg, Al₄Sr and Al₂Y phases. The dynamic recrystallization (DRX) kinetic was established based on an Avrami t...

The ultrafine grained (UFGed) 1050 Al plates with a thickness of 2 mm, which were produced by the accumulative roll bonding technique after five cycles, were friction stir butt welded to 2 mm thick 6061-T6 Al alloy plates at a different revolutionary pitch that varied from 0.5 to 1.25 mm/rev. In the stir zone, the initial nano-sized lamellar structure of the UFGed 1050 Al alloy plate transforme...