Intergranular stress corrosion cracking has occurred in BWR environments in non-sensitised, cold-worked austenitic stainless steel materials. The affecting parameters are so far not fully known, but deformation mechanisms may be decisive. The effect of cold deformation and nitrogen content on the deformation behaviour of austenitic stainless steels was investigated. The materials were austeniti...

During machining of stainless steels at low cutting -speeds, workpiece material tends to adhere to the cutting tool at the tool-chip interface, forming built-up edge (BUE). BUE has a great importance in machining processes; it can significantly modify the phenomenon in the cutting zone, directly affecting the workpiece surface integrity, cutting tool forces, and chip formation. The American Iro...

Numerical fracture toughness assessment of two types of steel, AISI 420 and AISI 431, has been conducted in this paper. The J-integral is chosen as a criterion for fracture behaviour comparison of compact type (CT) specimens made of investigated materials. The values of J-integral are determined through a newly developed algorithm using finite element (FE) stress analysis results of numerically...

In this study, some mechanical properties of borided and unborided four steels were investigated. Boronizing of steels was performed by powder pack method at 1210 K for 4 h. The hardness of borides, boride layer thickness and room temperature tensile properties were measured and it was observed that hardness and tensile properties strongly depend on chemical composition of steels. In addition, ...

this experimental study investigated the effects of quenching and tempering heat treatment on fatiguebehavior and also tempering temperature and time holding of aisi 1060 steel. at first, the specimenswere austenitized at 800˚c for 1 hour, and then were quenched in the water bath of 25˚c temperature.after that, tempering process was done at the temperature of 250˚c, 450˚c and 650˚c for 1 and 2 ...

Powder-actuated (also referred to as low velocity or powder-driven) fasteners are commonly used to attach cold-formed steel framing members, usually a track, to a concrete or structural steel support. Although commonly used, their behavior is less well understood than other fasteners such as screws, bolts and welds. The AISI Cold-Formed Steel Design Manual does not explicitly address powder act...

Implantation using stainless steels (SS) is an example where an understanding of protein-induced metal release from SS is important when assessing potential toxicological risks. Here, the protein-induced metal release was investigated for austenitic (AISI 304, 310, and 316L), ferritic (AISI 430), and duplex (AISI 2205) grades in a phosphate buffered saline (PBS, pH 7.4) solution containing eith...

This paper presents the results of time and temperature resolved analysis of changes in phase composition and stresses/residual stresses during quenching and martensitic transformation of steel. Sample temperatures up to 900°C were reached with a specially-designed furnace, in which fast cooling of sample is executed by gas quenching. Stress development during quenching followed the expected tr...