This paper presents the review of the Doubly fed Induction Generator (DFIG) based Wind Energy Conversion System (WECS). Basically the various challenges of the grid connected DFIG based wind turbine has been highlighted in this review. Nonlinear model of wind turbine with DFIG configuration are explained and a 1.2 MW, 50 Hz, 6 pole DFIG simulated using MATLAB/SIMULINK. Some important control is...

The paper analyzes the effects of harmonics in wind turbines by presenting a useful technique to reduce the effects of harmonics. In this paper by using a harmonic model of wind turbine, and using a harmonic reduction technique, the power quality of network will be improved and the number of harmonics decrease. The technique is combination of wavelet analysis and active filters. The results sho...

Maximizing turbine up-time and reducing maintenance costs are key technology drivers for wind turbine operators. Components within wind turbines are subject to considerable stresses due to unpredictable environmental conditions resulting from rapidly changing local dynamics. In that context, systems health management has the aim to assess the state-of-health of components within a wind turbine,...

Wind turbines are complex dynamic systems forced by stochastic wind disturbances, gravitational, centrifugal, and gyroscopic loads. Since their aerodynamics are nonlinear, wind turbine modelling is thus challenging. Therefore, the design of control algorithms for wind turbines must account for these complexities, but without being too complex and unwieldy. Therefore, the main contribution of th...

Typical wind turbine systems are sufficiently large so as to require extensive physical space for their installation and operation. These requirements preclude the use of turbines in crowded, urban environments. On the other hand, smaller turbine systems may find practical application as rooftop units, installed atop tall buildings. Such rooftop units must be much smaller than their ground-base...

(UC Berkeley/LBNL) for embarking on the initial analysis that formed the basis for this report, Eric Lantz (NREL) for guidance on the use of NREL's turbine cost and scaling model, and Naïm Darghouth (LBNL) for compiling data on wind turbine imports. The authors would also like to thank the following individuals for reviewing earlier drafts of this manuscript: and several anonymous reviewers. Of...

The proposed DOE/Sandia Scaled Wind Farm Technology Facility (SWiFT) hosted by Texas Tech University at Reese Technology Center in Lubbock, TX, will provide a facility for experimental study of turbine-turbine interaction and complex wind farm aerodynamics. This document surveys the current status of wind turbine wake and turbine-turbine interaction research, identifying knowledge and data gaps...

Every year the number of installed wind power plants in the world increases. The horizontal axis wind turbine is the most common type of turbine but there exist other types. Here, three different wind turbines are considered; the horizontal axis wind turbine and two different concepts of vertical axis wind turbines; the Darrieus turbine and the H-rotor. This paper aims at making a comparative s...

The paper presents both a numerical and an experimental approach to study the air flow characteristics of a novel small wind turbine and to predict its performance. The turbine model was generated based on impulse turbine principles in order to be employed in an omni-flow wind energy system in urban areas. The results have shown that the maximum flow velocity behind the stator can be increased ...

Aiming at the non-stationary and stall flutter problems of wind turbine blade caused by transient load fluctuations, the dynamic properties of wind turbine were studied, the blade was simplify to a cantilever beam in case of the action of shear deformation and cross section rotating effect were considered in this analysis, equations of the blade were established based on D'Alemberts' principle ...