Solar reactors featuring a circulating cyclone flow pattern provide enhanced heat transfer and longer residence time increasing the conversion efficiency. Cyclone flow also works in reducing particle deposition on solar reactor walls and exit, which is particularly an important issue in solar cracking reactors to avoid clogging. This paper focuses on the physics of cyclone formation inside a so...

The contribution describes the new measuring and protection system of the VR-1 training reactor. The measuring and protection system upgrade is an integral part of the reactor I&C upgrade. The new measuring and protection system of the VR-1 reactor consists of the operational power measuring and the independent power protection systems. Both systems measure the reactor power and power rate, ini...

We present the design and performance of a homebuilt high-pressure and high-temperature reactor equipped with a high-resolution scanning tunneling microscope (STM) for catalytic studies. In this design, the STM body, sample, and tip are placed in a small high pressure reactor ( approximately 19 cm(3)) located within an ultrahigh vacuum (UHV) chamber. A sealable port on the wall of the reactor s...

The implementation of hydrogenotrophic denitrification is limited due to safety concerns, poor H2 utilization and low solubility of H2 gas with the resulting low transfer rate. The current paper presents the main research work conducted on a pressurized hydrogenotrophic reactor for denitrification that was recently developed. The reactor is based on a new concept suggesting that a gas-liquid eq...

A microfluidic reactor for synthesizing cadmium selenide (CdSe) quantum dots (QDs) was synthesized out of a silicon wafer and Pyrex glass. Microfabrication techniques were used to etch channels into the silicon wafer. Holes were wet-drilled into the Pyrex glass using a diamond-tip drill bit. The Pyrex wafer was anodically bonded to the etched silicon wafer to enclose the microfluidic reactor. C...

Partial nitrification techniques, such as the continuously aerated SHARON process, have been denoted for quite a while as very promising for improved sustainability of wastewater treatment. Combination of such a SHARON process with the Anammox process, where ammonium is oxidised with nitrite to nitrogen gas under anoxic conditions, leads to cost-efficient and sustainable nitrogen removal from c...

Cometabolism of trichloroethylene (TCE) by phenol-fed enrichments was evaluated in four reactors with distinct phenol feeding patterns. The reactors were inoculated from the same source, operated at the same average dilution rate, and received the same mass of phenol over time. Only the timing of phenol addition differed. Reactor C received phenol continuously; reactor SC5 received phenol semic...

In this paper, discrete time higher integer order linear transfer function models have been identified first for a 500 MWe Pressurized Heavy Water Reactor (PHWR) which has highly nonlinear dynamical nature. Linear discrete time models of the nonlinear nuclear reactor have been identified around eight different operating points (power reduction or step-back conditions) with least square estimato...

An integral reactor design methodology was developed to address the optimal design of photocatalytic wall reactors to be used in air pollution control. For a target pollutant to be eliminated from an air stream, the proposed methodology is initiated with a mechanistic derived reaction rate. The determination of intrinsic kinetic parameters is associated with the use of a simple geometry laborat...

In this work the dynamic study of EPS (Extracellular Polymeric Substances) concentration and distribution during the operation of two different reactor configurations (UASB and EGSB) is presented, treating medium (5 g COD/l) and low-concentrated (0.5 g COD/l) wastewater. Medium-concentrated wastewater was supplied for granules maturation as well as for stabilisation of the process. The effect o...