OBJECTIVE The aim of this study was to evaluate the effect of neutral sodium fluoride (NNaF) gel and acidulated phosphate fluoride (APF) gel on the surface roughness of colored compomer (Twinky Star), conventional compomer (Compoglass F) and resin-modified glass-ionomer cement (RMGIC) (Photac-Fil). MATERIAL AND METHODS A total of 45 standardized disc-shaped specimens were prepared for each ma...

In this study OSB strands produced by a CAE 6/36 disk flaker from resaturated moso and guadua bamboo tissue were classified by surface quality and compared with industrial aspen OSB strands. Strands were first classified into three groups based on surface appearance and texture. The topographic features that characterize the surface were then measured using a laser surface profiler to give two ...

OBJECTIVES To compare and evaluate the root surface roughness after using two polishing instruments for root planing. MATERIALS AND METHODS This comparative study was carried out on a sample of ten extracted human teeth with twenty interproximal root surfaces. Control group 1 and 2: (n=20 root surface): Gracey Curettes, 15 vertical strokes. Test group 1 (n=10): control group 1 + Termination D...

Friction and wear tests were performed on AISI 1045 steel specimens with different initial roughness parameters, machined by a creep-feed dry grinding process, to study the friction and wear behavior on a pin-on-disc tester in dry sliding conditions. Average surface roughness (Ra), root mean square (Rq), skewness (Rsk) and kurtosis (Rku) were involved in order to analyse the influence of the fr...

At present, laser cutting is currently employed to cut metallic plates, due their good finish and dimensional quality, as well because of the flexibility process obtain different shapes. In present paper, surface roughness, accuracy, burr thickness thin plates 0.8 mm are studied functions parameters: pulse frequency, width, speed. Eight experiments were performed according a full 23 factorial d...

With nanotextured surfaces and interfaces increasingly being encountered in technological and biomedical applications, there is a need for a better understanding of frictional properties involving such surfaces. Here we report friction measurements of several nanostructured surfaces using an Atomic Force Microscope (AFM). These nanostructured surfaces provide well defined model systems on which...

AIM Compare surface roughness of 'aesthetic' nickel-titanium (NiTi) archwires with their dynamic frictional properties. METHODS Archwires investigated were: four fully coated tooth coloured [Forestadent: Biocosmetic (FB) and Titanol Cosmetic (FT); TOC Tooth Tone (TT); and Hawley Russell Coated Superelastic NiTi (HRC)]; two partially coated tooth coloured [DB Euroline Microcoated (DB) and TP A...

This paper presents an investigation on the effect of machining parameters on the surface roughness (centre line average roughness: Ra) and the optimal combination of process parameter for minimum Ra in wire electrical discharge machining (WEDM) of EN 31 steel using artificial bee colony (ABC) algorithm. The experimental studies are conducted by varying discharge current, voltage, pulse on time...

UNLABELLED Sintered porous silicon is a well-known seed for homo-epitaxy that enables fabricating transferrable monocrystalline foils. The crystalline quality of these foils depends on the surface roughness and the strain of this porous seed, which should both be minimized. In order to provide guidelines for an optimum foil growth, we present a systematic investigation of the impact of the thic...