The coefficient of restitution is a measure of energy dissipation in a system across impact events. Often, the dissipative qualities of a pair of impacting components are neglected during the design phase. This research looks at the effect of applying a thin layer of metallic coating, using thermal spray technologies, to significantly alter the dissipative properties of a system. The dissipativ...

Stainless steel (SS) is used for many commercial and industrial applications owing to its high resistance to corrosion. It is too hard to machine due to its high strength and high work hardening property. A surface property such as surface roughness (SR) is critical to the function-ability of machined components. SS is generally regarded as more difficult to machine material and poor SR is obta...

The change in near-tip stress field in Small Scale Yielding (SSY) for cracks located at an interface between two materials with different plastic work hardening is investigated. The difference in hardening is termed hardening mismatch, and is quantified through the parameter n, which is the difference in hardening exponent between the two materials. For cracks in elastic-ideally plastic materia...

Drought stress is the main cause of mortality of holm oak (Quercus ilex L.) seedlings in forest plantations. We therefore assessed if drought hardening, applied in the nursery at the end of the growing season, enhanced the drought tolerance and transplanting performance of holm oak seedlings. Seedlings were subjected to three drought hardening intensities (low, moderate and severe) for 2.5 and ...

Strain hardening capability is critical for metallic materials to achieve high ductility during plastic deformation. A majority of nanocrystalline metals, however, have inherently low work hardening capability with few exceptions. Interpretations on work hardening mechanisms in nanocrystalline metals are still controversial due to the lack of in situ experimental evidence. Here we report, by us...

CoHErrelation between weldability and improvement in properties is a key issue in materials science research. The objective of this work is to optimize the process parameters viz., aging temperature, aging time, solutionizing time, to enhance the hardness of Al6061 alloy. Hence, the present paper deals with hardness study of Tungsten Inert Gas welded 6061 aluminium alloy after age hardening und...

Shot peening is a process in which a stream of shot is blasted against an engineering component to generate a high compressive residual stress regime at the surface of the component. This paper describes a 3D finite element dynamic analysis of single shot impacting on a metallic component. The model is first validated against a published numerical study. A parametric study is conducted to inves...

It has long been a puzzle that the Raman optical modes shift to lower frequency or termed optical mode softening or redshift associated with the creation of Raman acoustic modes that shift to higher energy or called acoustic hardening or blueshift upon a nanosolid being formed and its size being reduced. Understandings of the mechanism behind the size-induced Raman shifts have been quite contro...

The microstructural evolution during low temperature ageing of two commercial purity alloys (Al1.2Cu-1.2Mg-0.2Mn and Al-1.9Cu-1.6Mg-0.2Mn at.%) was investigated. The initial stage of hardening in these alloys is very rapid, with the alloys nearly doubling in hardness during 20 h ageing at room temperature. The microstructural evolution during this stage of hardening was investigated using diffe...

Based on experimental results, a dislocation material model describing the dynamic strain aging effect at different temperatures is presented. One and two stage loading tests were performed in order to investigate the influence of the loading direction as well as the temperature influence due to the hardening mechanism. Bergström’s theory of work hardening was used as a basis for the model deve...