The corrosion resistant coatings used conventionally are susceptible to degradation, leading to pitting corrosion. This report summarizes the corrosion resistant nature of thin films of Cu-TiO2 coated on mild steel, in different corrosion environments. Nano meter thick (100nm, 125nm, 150nm) composite coatings were coated on steel substrate by RF magnetron sputtering technique. The required targ...

C and Z sections are two of the most common cold-formed steel shapes in use today. Accurate prediction of the bending performance of these sections is important for reliable and efficient cold-formed steel structures. Recent analytical work has highlighted discontinuities and inconsistencies in the American Iron and Steel Institute ~AISI! and Canadian Standards Association ~S136! design provisi...

The aim of this in vitro study was to investigate the frictional characteristics of two types of self-ligating brackets ('A' Company Damon SL and Adenta Time brackets) and two types of pre-adjusted edgewise brackets (TP Tip-Edge and 'A' Company Standard Twin brackets). The test brackets were glued to steel bars and aligned using a preformed jig. Five combinations of archwire size and material w...

The heat-resistant steel after aluminized was treated by laser shock processing (LSP) with high power Nd:YAG laser, and then was tensile tested at 400 . The effects of the high °C -temperature behavior after LSP were analyzed from residual stress and fracture organization. The results showed that the yield strength and tensile strength of heat-resistant steel after aluminized were improved obvi...

OBJECTIVE To compare the influence of archwire material (NiTi, beta-Ti and stainless steel) and brackets design (self-ligating and conventional) on the frictional force resistance. MATERIAL AND METHODS Two types of brackets (self-ligating brackets - Smartclip, 3M/Unitek - and conventional brackets - Gemini, 3M/Unitek) with three (0, 5, and 10 degrees) slot angulation attached with elastomeric...

Structural fuses, easily replaceable sacrificial elements to dissipate seismic energy while preventing damage to the gravity loadresisting structural system, are proposed as part of a multicolumn accelerated bridge construction (ABC) pier concept. Different types of structural fuses are investigated to compare the effect of each on ABC bridge bents. The piers of a three span-continuous bridge p...

Slow strain rate test (SSRT) represent a dynamic slowly increasing strain imposed by an external means on uniaxial tension specimen according to ASTM G 129 standard. It is used for relatively rapid screening or comparative evaluation of environmental, processing or metallurgical variables that can affect resistance of material. Testing has been accomplished on low-alloyed boiler steel 14MoV6-3 ...

The biomechanical characteristics of 1.2 mm diameter allogeneic cortical bone pins harvested from the canine tibia were evaluated and compared to 1.1 mm diameter stainless steel pins and 1.3 mm diameter polydioxanone (PDS) pins using impact testing and four-point bending. The biomechanical performance of allogeneic cortical bone pins using impact testing was uniform with no significant differen...

Whole bone bending tests are commonly used in mechanical evaluation of long bones. Reliable information about the midshaft can only be obtained if the bending moment is uniformly distributed along the shaft, and if the distribution of the bending stress is not adversely influenced by rigid clamping of the bone ends. A testing device was developed to determine bending stiffness of long bones in ...

Communication about infant lung function testing, as in any other field of science and medicine, requires the use of symbols, abbreviations, units, prefixes and suffixes. These should be unambiguous, and this is achieved by rigorous standardization by international scientific and medical bodies, and by governments. The present recommendations derive from the report of the European Community for...