Studies are on-going to establish the suitability of tire shreds in the landfill bottom drainage layer, to minimize clogging. Four experimental columns were constructed in which were 500 mm long and 200 mm in diameter. They were filled with different fillers and with a different amount of tire shreds. The most important problem with drainage filler in landfills is clogging. Over long periods of...

A new type of holonomic omnidirectionul vehicle which consists of wheel mechanisms without free rollers but with conventional tires is presented. We first present a concept of the new driving wheel mechanism with a tire in the conventional style such QS a rubber tire or a pneumatic tire,"Offset Steered Driving Wheel". The configuration of the wheel has an offset distance between a wheel axle an...

Occupational accidents and injuries present a serious social, medical and economical problem in Serbian industries in transition. The purpose of this study is to estimate the number and average annual rate of occupational accidents and traumatic injuries in Serbian industries in transition, between 1992 and 2003, and to estimate the effects of a preventive safety program in the rubber manufactu...

This paper examines recent horror films in the US in relationship to the economic collapse of 2008 and the Great Recession. Using Rubber (2010) and Iron Invader (2011), it explores how the “killer commodity” resonates with working-class anxieties of dispossession and disposability, especially in the auto industries of the places where the films are set and produced: the US and France. The films...

Often when vehicles interact with roadside hardware like guardrails, bridge rails and curbs, the interaction between the roadside hardware and the tire causes the tire to lose its air seal and "blow-out". Once the seal between the rim and rubber tire is lost, the tire deflates. The behavior of the deflated tire is much different than the behavior of an inflated tire such that when this behavior...

OBJECTIVES To estimate the prevalence of sensitisation to natural rubber latex in latex tappers and latex glove factory workers, and to relate this to airborne exposure to latex. METHODS Five hundred workers employed in three latex glove factories, 314 tappers, and 144 college students (control group) were studied. The workers in the glove factories were classified into three exposure groups;...

A prediction method for rubber curing process has historically received considerable attention in manufacturing process for rubber article with relatively large size. In recent years, there exists increasing demand for simulation driven design which will cut down the cost and time required for product development. In case of the rubber with relatively large dimensions, low thermal conductivity ...

Solid waste management is one of the major environmental concerns in the United States. Over 5 billion tons of non-hazardous solid waste materials are generated in USA each year. Of these, more than 270 million scrap-tires (approximately 3.6 million tons) are generated each year. In addition to this, about 300 million scrap-tires have been stockpiled. Several studies have been carried out to re...

Mixing of filler particles with elastomers is one the most important steps in tire manufacturing process. Precipitated Silica (Si), as a filler, shows enhanced properties compared carbon black when incorporated an elastomer such low rolling resistance, high wet grip performance, and wear resistance. According to standard rubber mixing process, fragmentation during must yield breakage size that ...

Electronic controls cannot always compensate for the destabilization of a poorly designed vehicle caused by tire delamination. Axle tramp caused from rubber strips on the track showed axle skate [1]. Further research, reported at ESV 2007 [2] demonstrated that lumps on a single rear tire caused 15+ degrees/g of oversteer. The Engineering Institute has shown that the process of tire delamination...