Biomechanical model of soft tissue derived from experimental measurements is critical for developing a reality-based model for minimally invasive surgical training and simulation. In our research, we focus on developing a biomechanical model of the liver under large tissue deformation. This paper presents the experimental apparatus, experimental data, and methods to model the experimental data ...

A SLIP line theory governing states of incipient plane flow at the yield point load is developed for anisotropic rigid/plastic materials which exhibit a reduced yield criterion, governing states of plane flow, that depends only on the deviatoric parts of the in-plane stress tensor. It is shown that every homogeneous, incompressible material which complies with the principle of maximum plastic w...

The hypothesis that ventricular in-plane tensile wall stresses are the major determinant of systolic coronary flow was investigated in this study. We measured coronary artery inflow in the maximally vasodilated bed of the isolated beating septum (n = 10) during two modes of contraction characterized by markedly different levels of developed in-plane stress. An increase in contractility was indu...

Forming limit curves are used as a parameter in finite element analysis to control the material's level of formability. In this research, forming limit diagram (FLD) of SS304L sheet was obtained by ABAQUSfinite element software. In practice, the experimental determination of a forming limit curve is a very time-consuming procedure which requires special and expensive equipment. Forming limit di...

BACKGROUND The benefits of a decreased slice thickness and/or in-plane voxel size in carotid MRI for atherosclerotic plaque component quantification accuracy and biomechanical peak cap stress analysis have not yet been investigated in detail because of practical limitations. METHODS In order to provide a methodology that allows such an investigation in detail, numerical simulations of a T1-we...

Plasticity-induced, roughness-induced and oxide-induced crack closures are reviewed. Special attention is devoted to the physical origin, the consequences for the experimental determination and the prediction of the effective crack driving force for fatigue crack propagation. Plasticity-induced crack closure under plane stress and plane strain conditions require, in principle, a different expla...

Surfactants at air/water interfaces are often subjected to mechanical stresses as the interfaces they occupy are reduced in area. The most well characterized forms of stress relaxation in these systems are first order phase transitions from lower density to higher density phases. Here we study stress relaxation in lipid monolayers that occurs once chemical phase transitions have been exhausted....

The Rotary-Draw Bending (RDB) process is a distinguished process employed for the precision cold bending of a hollow tube with small radius bends using Numerical Control (NC) machines. This research presents an analytical model based on the power law hardening model for the RDB processing of rectangular thin tubes. Based on the constraints of the tube in the dies and its thinness, the plane str...

In this paper a composite plate with similar unidirectional fibers is considered. Assuming orthotropic structure, theory of elasticity is used for investigating the stress concentration. Also, complex variable functions are utilized for solving the plane stress problems. Then the effective characteristics of this plate are studied numerically by using ANSYS software. In this research a volume e...