The matrix converter has many advantages in wind power system applications. Matrix converter is compact and highly efficient because it directly converts generated power from AC generator to AC grid without intermediate DC bus while conventional back-to-back converter systems requires many electrolytic capacitors in DC link bus which are bulky and have short life-time. Matrix converter has both...

this paper proposes a flexible power electronic transformer (fpet) for the application in the micro-grids. the low frequency transformer is usually used at the point of common coupling (pcc) to connect the low voltage grid and utility network to each other. the conventional 50hz transformer results in enhanced low voltage-grid power management system during grid-connected operation. in this pap...

Power electronic converters are essential part of hybrid fuel cell automotive application systems. The converter needs to provide high-voltage ratio for a wide range of input voltage. In addition, the converter should have high efficiency for a wide range of duty cycle control range. A four-phase floating interleaved boost converter (FIBC) is analysed and a small-signal AC model using an averag...

Multicell converter are a very interesting alternative for medium and high power drives. This paper presents a new configuration of double flying capacitor (DFCM) converter. The main advantages of the proposed converter in comparison with FCM and stacked multicell converter are doubling the rms and the number of output voltage levels, improving the output voltage frequency spectrum, and cancell...

In this paper, a new topology for cascaded multilevel converter based on sub multilevel converter units and full-bridge converters is proposed. The proposed topology significantly reduces the number of dc voltage sources, switches, IGBTs, and power diodes as the number of output voltage levels increases. Also, an algorithm to determine dc voltage sources magnitudes is proposed. To synthesize ma...

In this paper, an interleaved soft switching boost converter for a Photovoltaic Power Conditioning System (PV-PCS) with high efficiency is proposed. In order to raise the efficiency of the proposed converter, a 2-phase interleaved boost converter integrated with soft switching cells is used. All of the switching devices in the proposed converter achieve zero current switching (ZCS) or zero volt...

This paper presents the comparative analysis of improved quality three phase AC/DC boost converters, using SIMULINK. Comparison of three phase controlled single switch and six switch AC/DC boost converters have been done to identify the boost converter with low cost/small size/high efficiency for three phase system. Three phase AC/DC boost converters with improved quality in terms of power fact...

This paper proposes a novel soft-switching singlephase ac–dc–ac converter to give high input power factor and low current distortion on the rectifier side and provide clean and stable ac voltage on the inverter side. The proposed converter uses a new zero voltage switching (ZVS) strategy to get ZVS function. Besides operating at constant frequency, all semiconductor devices operate at soft-swit...

The series capacitor buck converter is a dc-dc converter topology that uniquely merges a switched capacitor circuit and a multiphase buck converter. Many of the challenges faced by conventional buck converters are overcome by this converter topology. This enables efficient, high frequency operation and significantly smaller solution size. The series capacitor buck converter has beneficial chara...

Abstract. This paper proposes a novel soft-switching dual full-bridge converter with shared lagging leg and dual outputs in series. Resonant clamp circuits are employed across the secondary rectifiers to reduce the voltage overshoots of the secondary rectifiers, as well as extinguish the primary current during the freewheeling interval. Full Zero-Voltage-Switching (ZVS) range of the lagging leg...