A broadband input matching technique for low noise amplifiers (LNAs) is presented which exploits an active feedback network to achieve better noise performance. The presented matching scheme is compared to the common-gate and conventional noise canceling structures. The noise performance of the presented technique is similar to that of the conventional noise canceling technique with much less p...

Envelope distortion in transconductance mixers is analyzed in this paper. The analysis consists of a simplified theoretical study, simulation results, and measurements about several implemented mixers. The studied mixers are active single-balanced and double-balanced structures. A theoretical mismatch analysis is carried out instead of a complex mixer nonlinearity analysis; this gives an intuit...

At 14:30 I will give a short introduction to my thesis You are most welcome to attend the introduction, the defense and the reception afterwards. Abstract Tunable on-chip Radio Frequency (RF) filtering is highly desirable for cost effective wireless communication devices. As mobile wireless devices increasingly support multiple RF-bands, tunable RF filtering is wanted. The tremendous growth of ...

Introduction Noise figure (NF) and the third-order intercept point (IP3) are used in radio receiver link budget analysis as a means to quantify the effects of device noise and nonlinearity on the sensitivity of the radio. Analog-to-digital converters (ADCs) are used in radio receivers to convert the signal from the analog domain to the digital domain. NF and IP3 typically are not specified for ...

This paper describes calibration techniques for downconversion mixers used in integrated direct-conversion receivers. A method of achieving a high even-order intermodulation rejection is presented. Using the method presented, the receiver second-order input intercept point (IIP2) can always be improved by more than 20 dB. The minimum achieved receiver IIP2 after calibration is +38 dBm. A techni...

We have proposed a 2 GHz CMOS Differential Low Noise Amplifier (LNA) for wireless receiver system. The LNA is fabricated with the 0.18 μm standard CMOS process. Cadence design tool Spectre_RF is used to design and simulation based on resistors, inductors, capacitors and transistors. Power constrained methodology is used for the design of Differential Low Noise Amplifier. Consuming 9mA current a...

RF-tunable blocker-tolerant receivers (RXs) enhance the flexibility of multiband multistandard radios at low cost (Fig. 2.4.1). The mixer-first RX [1] delays the signal amplification to baseband (BB) by frequency-translating the BB lowpass response to RF as bandpass. This raises the out-of-band (OB) IIP3 (27dBm) at the expense of NF (5.5dB) and power (60mW) due to no RF gain. The noisecancellat...

This paper describes a combination of a Weaver mixer and an N-path filter for a superheterodyne receiver with a reconfigurable frequency plan. It uses an N-path topology driven with two different frequencies, effectively realizing a frequency shift together with band-pass filtering. To reduce transfers via harmonics other than the fundamental, a harmonic rejection scheme is used. A 28 nm FDSOI ...

A compact digitally-controlled single-stage variable gain amplifier (VGA) is introduced, which doubles the dB-linear range through the reconfiguration, saves power by 50% while maintaining the same linearity performance compared to those of the previous design. Implemented in 0.18 mm CMOS technology, the 5-bit digitally-controlled VGA achieves dB-linear gain range of 42 dB (221 to 21 dB) with g...