Magnetic materials, both hard and soft, are used extensively in several components of particle accelerators. Magnetically soft iron–nickel alloys are used as shields for the vacuum chambers of accelerator injection and extraction septa; Fe-based material is widely employed for cores of accelerator and experiment magnets; soft spinel ferrites are used in collimators to damp trapped modes; innova...

We study the low-temperature electrical and thermal conductivity of CoSi Co 1? x M Si alloys (M = Fe, Ni; ? 0.06). Measurements show that Fe decreases at > 0.01 by an order magnitude compared with pure CoSi. It was expected both lattice electronic contributions to would decrease in alloys. However, our experimental results revealed temperatures below 20 K, Fe- Ni-containing is several times lar...

Fe-Ni alloys of meteoritic composition were solidified by a plane front solidification technique. Distribution coefficients of Ni, P, Ir, Ge, and Cu were determined from the composition data of the plane front solidified alloys. Equations that describe the distribution coefficients (P, Ni, Ir, Ge, and Cu) as a function of S and P content as well as S to P ratio were used to calculate solute par...

Introduction: The Stardust mission obtained the first dust samples in the coma of an active comet for laboratory analyses. Earlier chemical data on dust from an active comet came from the GIOTTO and VEGA missions to comet Halley [1]. For decades aggregate interplanetary dust particles (IDPs) were available from parent bodies other than those of meteorites [2], i.e. comets or comet-like bodies. ...

Atomic configurations in P phase Cu-Al-Ni, Cu-Au-Zn and Cu-Zn-A1 ternary alloys before and after martensitic transformations, and occupancy sites of third elements X in the B2 parent lattice of Ti-Ni-X ternary alloys, where X = 3d elements, Pd and Au, have been investigated by means of an electron chanueling enhanced microanalysis method, called ALCHEMI. Large increases in M, and A, temperature...

The article contains computational data of electronic structure and crystal stability of two sigma-phases, namely Fe-Cr-Co and Fe-Cr-Ni, using the Korringa-Kohn-Rostoker method (KKR) for electronic band structure calculations. Total energy values, ET , calculated for the number of ordered unit cells with various atomic concentrations and sublattice occupancies are reported. In parallel, obtaine...

Superplastic bonding was performed using electrodeposited Ni and Ni-B to apply low-temperature diffusion of carbon steel. Electrodeposited were bonded at 450℃ in air a strain rate 1 × 10−4 s−1. The shear test measured the bond strength, maximum strength 69 MPa obtained. Since obtained is comparable that by steel 0.5Tm, it possible decrease temperature 0.4Tm applying this boning process. depende...

Both magnetic-field-induced reverse martensitic transformation (MFIRMT) and mechanical properties are crucial for application of Ni-Mn-Sn magnetic shape memory alloys. Here, we demonstrate that substitution of Fe for Ni can simultaneously enhance the MFIRMT and mechanical properties of Ni-Mn-Sn, which are advantageous for its applications. The austenite in Ni44Fe6Mn39Sn11 shows the typical ferr...