This paper presents efficient procedures to model multistage flows using Fourier-based methods. The Favre-averaged nonlinear harmonic method is extended compute by introducing rotor–rotor or stator–stator interactions. A unified treatment transfer disturbances through blade–row interfaces also formulated. performance of the proposed demonstrated in a compressor and turbine with different levels...

Tris paper, through analy3is to the specific power of the compressor, indicates that to reduce the power loss caused by friction is an important way to reduce the specific power of the compressor, investigates the realizability employing a single piston ring or a piston ring with small elasticity in the high speed double acting compressor, and raises a standpoint for a high speed double acting ...

In this paper, we propose an FPGA design of an audio signal level compressor, based on an approximation algorithm using a polynomial. To implement a compression characteristic in a digital audio system, the gain calculation with fractional numbers is performed by using a polynomial expression to approximate the power operation, then the compressor can be designed with a number of additions, mul...

A design point simulation and adaptation of anindustrial GE LM2500+ gas turbine engine is presented. The design point is chosen when the engine runs steadily at operating point and close to the nominal design condition at 29MW power output. The targeted performance parameters are the fuel flow rate (FF), the compressor exit total pressure (P3), the compressor turbine total exit temperature (T8)...

A miniature homogenous charge compression ignition (HCCI) free-piston engine compressor aimed at an ankle-foot orthosis application is described. Analysis of the human ankle shows that a fluid power source in the neighborhood of 10 W is needed. To account for compressor and actuator inefficiencies, the power output at the engine cylinder is designed to be 30 W. A compact engine compressor packa...

T he increase of the thrust-to-weight ratio of modern gas-turbine engines results in higher loads and a reduced number of blades and stages for the compressor. The designer must ensure the acceptable performance of each compressor stage (efficiency and stable operating range) and control the rising risk of blade boundary layer separation. This can be obtained using passive or active control dev...

An analytical study was carried out to investigate the performance of an oil supplying system of a variable speed compressor using a commercial CFD program. The simulations for the oil supplying system with the oil and air mixture were performed by varying compressor speed from 40 Hz to 90 Hz. Comparing the predicted with the measured data on the modified scroll compressor validated the simulat...

Supervision of the performance of an industrial gas turbine is important since it gives valuable information of the process health and makes efficient determination of compressor wash intervals possible. Slowly varying sensor faults can easily be misinterpreted as performance degradations and result in an unnecessary compressor wash. Here, a diagnostic algorithm is carefully combined with non-l...

A compressor is an automatic gain control effect that scales the output level of a signal based on the input level. If the input level is above a certain threshold, the compressor reduces the gain of the signal based on how high the input signal is above the threshold. The 1176LN is a hardware compressor originally produced in the late sixties. The circuitry has been tweaked several times to de...

This study involves the development of a fmite element model of a hennetic reciprocating compressor for noise prediction applications. Inherent difficulties in developing the finite element model of a complicated structure are discussed and appropriate modeling strategies are evolved. The development of the complete compressor fmite element model is carried out in two stages modeling of the com...