Introduction In general, the twentieth century marked the first major incursion of chemists into the world of tribology. Driven partly by the need for improved lubricants for new machines developed in the first few decades of the century, and partly by new analytical capabilities, lubricant chemists and tribochemists were to become full partners in the science of tribology. In this review we co...

Lubrication is a phenomenon of immense practical importance and fundamental scientific interest, and the automobile engines of the future are envisioned by the Partnership for a New Generation Vehicle will require the development of improved lubricants that perform well at higher operating temperatures and higher engine speeds. The rheological properties of liquid alkanes of intermediate molecu...

Topical glaucoma therapy is a long termed, usually lifelong. Antiglaucomatous drugs have toxic effects on ocular surface, due to preservative toxicitiy or the drug itself. Adding a lubricant eyedrops to antiglaucomatous therapy, especially if considering the preservative used, can have protective effect. The purpose of this study was to evaluate the stabilty of precorneal tear film in glaucoma ...

The loss of an eye is an emotional and psychological setback to the patient. An ocular prosthesis is created to restore the lost anatomical structure and to correct the cosmetic defect. The tear reflexes do not function at optimal levels in anophthalmic sockets which make prosthesis wear uncomfortable. This case report presents an innovative hollow ocular prosthesis with functional lubricant re...

The object of this paper is to study the effects of lubricant film flow, pressurized and sheared between two parallel rough surfaces in sliding motion. The influence of microscopic surface roughness on lubricant film flow macroscopic behavior is described through five nondimensional parameters called flow factors. These macroscopic transport parameters are related to the local geometry of apert...

The study investigates the mechanism of ring-liner lubrication in the vicinity of the top and bottom dead centres of an internal combustion engine. Predicting lubricant transient behaviour is critical when the inlet reversal leads to thin films and inherent metal-to-metal interaction. It was found that the cavitation, which is located at the trailing edge of the contact before reversal, briefly...

Experimental investigations have been conducted for determination of effectiveness of employing a combination of three particle sizes (40 nm size, 1.75 μm size and 53 μm size) of Molybdenum Disulphide as anti-wear additive in a commercial lubricant. The conformal block and disk configuration has been used to conduct experiments for determination of wear of the sliding surfaces. The performance ...

The correct tribological design will have a considerable effect on a gear’s service life and efficiency. The purpose of this thesis is to clarify the impact of variation in the gear tooth flank tribological system on the gear contact load capacity – to increase the understanding of how surface topography and lubricant interact. In this thesis the variation in surface topography inherent in the ...

This work proposes a numerical model that incorporates the effect of lubricant inertia on the hydrodynamic pressure distribution, fluid film reaction forces, and the fluid velocity component profiles for finite-length open-ended squeeze film dampers (SFDs). Firstly, the thin film flow equations for the SFD in presence of fluid inertia effects are introduced. Furthermore, a small first-order per...