In some systems with hysteresis behavior like Shape Memory Alloy (SMA) actuators and Piezo actuators, we essentially need an accurate modeling of hysteresis either for controller design or performance evaluation. One of the most interesting Hysteresis non-linearity identification methods is Preisach model in which hysteresis is modeled by linear combination of elemental operators. Despite good ...

The present paper will describe an approach for the simultaneous real-time compensation of hysteresis, creep and force-dependence effects of a piezoelectric stack actuator by a feed-forward controller. The basis of the feed-forward controller is given by so-called complex creep and hysteresis operators, which when adequately implemented, lead to a precise model of the creep and hysteresis chara...

Reaction of the dinuclear complex [Mn2O2(bpy)4](ClO4)3 with H3cht (cis,cis-l,3,5-cyclohexanetriol) in MeCN produces the complex [Mn3(Hcht)2(bpy)4](ClO4)3.Et2O.2MeCN (1.Et2O.2MeCN). Dc magnetic susceptibility measurements reveal the existence of weak ferromagnetic exchange between the three Mn ions, leading to a spin ground state of S = 7, with D = -0.23 cm(-1). W-Band (94 GHz) EPR measurements ...

Direct torque control (DTC) is a new method of induction motor control. The key issue of the DTC is the strategy of selecting proper stator voltage vectors to force stator flux and developed torque within a prescribed band. Due to the nature of hysteresis control adopted in DTC, there is no difference in control action between a larger torque error and a small one. It is better to divide the to...

In a balanced three phase system, only harmonics of positive sequence(7 th , 13 th ,..etc) and negative sequence (5 th , 11 th ,…etc) are produced. However, the harmonic currents produced by single phase non-linear loads like switch-mode power supplies in computer which are connected between phase to neutral injects third order zero sequence harmonics (3 rd ,9 th ,15 th …etc) (Mehmet et al 2008...

Abstract: Shunt Active power filters (SAPF) technology has emerged nowadays as a very suitable option for power quality improvement in electrical power systems control. This paper presents the simulation study of a fuzzy logic hysteresis band current controlled, three-phase SAPF to enhance power quality by harmonic elimination, power-factor correction, reactive power compensation and balancing ...

Although the preferred transition speed (PTS) reported by various researchers is relatively consistent, the amount of observed hysteresis (difference between the walk-run and the run-walk transition speed) varies considerably. Variations in reported hysteresis appear to be related to the protocol used to determine the transition speeds. This investigation compared the PTS, and the amount of hys...

Large changes in hysteresis are reported as a function of applied stress under thermal cycling experiments in NiTi single crystals. In the low Ni alloy the thermal hysteresis expanded with increasing stress while in the high Ni alloy the thermal hysteresis contracted with increasing stress. The results in both cases meet the limit obtained from Differential Scanning Calorimetry at zero stress. ...

The haemolymph of larvae of Tenebrio molitor contains a factor which produces a thermal hysteresis (a difference between the freezing and melting points) of approximately 0-75 °C. When larvae were acclimated to low temperatures or short photoperiod the thermal hysteresis increased more than twofold. Coincident with the increase in thermal hysteresis the supercooling points and lower lethal temp...