Measurements of the flow field around a low pressure turbine blade are presented. The purpose of the experimental study is to investigate the detailed transition and separation characteristics on low pressure turbine blades. The present study focuses on the effect of Reynolds number on the formation of separation bubbles on the turbine blade surface. Specific attention is paid to the flow withi...

Title Type wind turbine control and monitoring advances in industrial control PDF wind turbine control systems principles modelling and gain scheduling design advances in industrial control PDF optimal control of wind energy systems towards a global approach advances in industrial control PDF dynamic modelling of gas turbines identification simulation condition monitoring and optimal control ad...

Manufactured single crystal components using Ni-base super alloys are routinely used in the hot sections of aero engines and industrial gas turbines due to their outstanding high temperature strength, toughness and resistance to degradation in corrosive and oxidative environments. To control the quality of the single crystal turbine blades, particular attention has been paid to grain selection,...

Gas turbines can be exposed to microparticle ingestion throughout their lifespan due to the harsh conditions, like deserts, in which many of them operate. Microparticles can wear out turbine blades and clog cooling holes which may result in the failure of the blade. To measure the interaction of microparticles with turbine components the Coefficient of Restitution (COR) is used. The objective o...

This paper presents PID controller designs based on NARMAX and feedforward neural network models of a Spey gas turbine engine. Both models represent the dynamic relationship between the fuel flow and shaft speed. Due to the engine non-linearity, a single set of PID controller parameters is not sufficient to control the gas turbine throughout the operating range. Gain-scheduling PID controllers ...

A new generation of small scale (less than 20 MWe) biomass fueled, power plants are being developed based on a gas turbine (Brayton cycle) prime mover. These power plants are expected to increase the efficiency and lower the cost of generating power from fuels such as wood. The new power plants are also expected to economically utilize annual plant growth materials (such as rice hulls, cotton g...

Large-eddy simulation (LES) has traditionally been restricted to fairly simple geometries. This paper discusses LES of reacting flows in geometries as complex as commercial gas turbine engine combustors. The incompressible algorithm developed by Mahesh et al. (J. Comput. Phys., 2004, 197, 215–240) is extended to the zero Mach number equations with heat release. Chemical reactions are modeled us...

Film cooling technique has been successfully applied to gas turbine blades to prevent it from the hot flue gas. However, a continuous demand of increasing the turbine inlet temperature to raise the efficiency of the turbine requires continuous improvement in film cooling effectiveness. The concept of injecting mist (tiny water droplets) into the cooling fluid has been proven under laboratory co...

Manufactured single crystal components using Ni-base super alloys are routinely used in the hot sections of aero engines and industrial gas turbines due to their outstanding high temperature strength, toughness and resistance to degradation in corrosive and oxidative environments. To control the quality of the single crystal turbine blades, particular attention has been paid to grain selection,...

A novel slow-growing, obligatory heterofermentative, nonstarter lactic acid bacterium (NSLAB), Lactobacillus wasatchensis WDC04, was studied for growth and gas production in Cheddar-style cheese made using Streptococcus thermophilus as the starter culture. Cheesemaking trials were conducted using S. thermophilus alone or in combination with Lb. wasatchensis deliberately added to cheese milk at ...