AIM The aim of this study was to compare frictional resistance which was produced between conventional brackets (0.022 slot Otho-Organiser) and self ligating brackets (active Forestadent and passive Damon III) by using various arch wire combinations (0.016 Niti, 0.018 Niti, 0.017 x 0.025 SS and 0.019 x 0.025 SS). METHODS An experimental model which consisted of 5 aligned stainless steel 0.022...

The tribological properties of FeCl2, measured using an ultrahigh vacuum tribometer, are compared with those of KCl. The friction coefficient of an FeCl2 film evaporated onto iron in ultrahigh vacuum decreases to ∼0.08 after the deposition of a film ∼40 Å thick. This value is in good agreement with that measured for reactively formed FeCl2 films in a pin and v-block apparatus. The contact resis...

Sliding bearings with low coefficient of friction enable the base isolation system with longer natural period than previous ones and to be effective even for small to medium earthquakes. This paper introduces the sliding bearings with low coefficient of friction, which is almost under 0.03. It is shown that newly developed materials for the sliding bearings contribute to reduce coefficient of f...

Objectives. The aim of this study was to assess the influence of resistance to sliding on expression of superelastic properties of NiTi wires. Methods and Materials. A three-point bending test was performed for 0.014 NiTi wire engaged in self-ligating (Damon, SmartClip, In-Ovation) and conventional brackets (Victory) ligated with regular and reduced friction modules (Slide). The wire was deflec...

Ti-TiC-TiC/DLC gradient nano-composite films have been prepared on the NiTi substrates by the technique of plasma immersion ion implantation and deposition (PIIID) combining with plasmaenhanced chemical vapor deposition (PECVD). The influence of C2H2 flow rate ranging from 30sccm to 50sccm on the chemical structure, microstructure, mechanical properties and corrosion resistance of resulting thi...

Friction between archwires and labial brackets has received considerable attention; however, information on the frictional behaviour of commercially available lingual brackets is limited. The aim of this study was to investigate the frictional resistance resulting from a combination of lingual orthodontic brackets (7th Generation, STb, Magic, and In-Ovation L) and stainless steel archwires at 0...

In the present study, plate impact pressure±shear friction experiments are conducted to provide insight into timeresolved dry sliding characteristics of metal on metal at normal pressures of approximately 1.5 GPa, slip speeds up to 60 m/s and interfacial temperatures as high as 8008C. The plate impact friction experiments represent a signi®cant improvement over conventional dynamic friction exp...

The interfacial structure/property relationships of a representative composite system consisting of SIC (SCS-6) fibers in a T&Al + Nb intermetallic alloy have been investigated. Two samples were fabricated at 1040°C with different exposure times in order to vary the amount of fiber-matrix reaction. This resulted in samples with reaction zone thicknesses (S) of 1.1 and 1.7pm, while ensuring roug...

This paper describes a computational method to calculate the friction force between two rough surfaces. In the model used, friction results from forces developed during elastic deformation and shear resistance of adhesive junctions at the contact areas. Contacts occur between asperities and have arbitrary orientations with respect to the surfaces. The size and slope of each contact area depend ...