We present a method for estimating seismic attenuation based on frequency shift data. In most natural materials, seismic attenuation increases with frequency. The high-frequency components of the seismic signal are attenuated more rapidly than the low-frequency components as waves propagate. As a result, the centroid of the signal’s spectrum experiences a downshift during propagation. Under the...

In this paper, we report attenuation characteristics of aluminum nitride (AIN) film-based surface acoustic waves (SAWs) in liquids and their potential as liquid ethanol sensors. An AIN film-based SAW resonator was fabricated for liquid sensing application. The fabricated SAW device had a Rayleigh wave mode at a resonant frequency of 147.1 MHz and a low temperature coefficient of frequency (TCF)...

In this paper, we analyze a distributed amplifier based on input/output attenuation compensation. The analysis is carried out for a HEMT transistor; and a constant-k section filter is used to calculate the amplifier’s characteristics such as attenuation factor, phase constant and gain. The proposed design approach enables us to examine the tradeoff among the variables, which include the type an...

An analytical inversion formula for the exponential Radon transform with an imaginary attenuation coefficient was developed in 2007 (2007 Inverse Problems 23 1963-71). The inversion formula in that paper suggested that it is possible to obtain an exact MRI (magnetic resonance imaging) image without acquiring low-frequency data. However, this un-measured low-frequency region (ULFR) in the k-spac...

This paper presents several fundamental frequency-domain bounds for a non-negative impulse response (NNIR) filter. Upper-bounds on power spectral attenuation and power spectral gain in geometrically spaced frequency regions are derived, when power spectral attenuation near frequency zero is limited. By analyzing the tightnesses of these bounds, the relationship between the maximally allowable p...

Underwater acoustic communications constitute a very difficult issue since the transmission channel is severely doubly dispersive. Indeed, radio waves suffer from strong attenuation so that the only solution is to use acoustical modems. Thus, achievable bandpass is very reduced (typically less than 20kHz) and narrowband signal approximation cannot be assumed since sound velocity is around 1500 ...

There is given a minimum-phase plant transfer function, with prescribed bounds on its parameter values. The plant is imbedded in a two-degree-of freedom feedback system, which is to be designed such that the system time response to a deterministic input lies within specified boundaries. Subject to the above, the design should be such as to minimize the effect of sensor noise at the input to the...

The intention of this study is the analysis of thermal behavior of functionally graded beam (FGB). The distribution of material properties is imitated exponential function. For thermal loading the steady state of heat conduction with exponentially and hyperbolic variations through the thickness of FGB, is considered. With comparing of thermal behavior of both isotropic beam and FGB, it is appea...

We present results of a study of third sound in thick He films in circular resonator geometry. Frequency and line shapes of third sound resonances are measured for temperatures between 0.3 and 2.1 K in saturated films approximately 30 nm thick. From these measurements we calculate the attenuation of the sound. We find that the attenuation at a given temperature is a function of history of the f...