The maximal calcium-activated isometric tension produced by a skinned frog single muscle fiber falls off as the ionic strength of the solution bathing this fiber is elevated declining to zero near 0.5 M as the ionic strength is varied using KCl. When other neutral salts are used, the tension always declines at high ionic strength, but there is some difference between the various neutral salts u...

The huge quantity of concrete is consumed by the construction industry all over the world, probably second largest after water. In India, the conventional concrete is produced by using natural sand from riverbeds as fine aggregate. Dwindling sand resources poses the environmental problem and hence government restrictions on sand quarrying resulted in scarcity and significant increase in its cos...

Use of composites for a range of structural application in aircrafts, space-crafts, automobiles, etc., has widely spread in the last few years. Other than weight reduction, cut-outs provide pathways to link different aircraft parts. In this paper, an experimental investigation was conducted to study the effect of a cut-out on the tensile strength of the fiber glass/ epoxy composite plate. Geome...

Ab&act The structural performance of medium density fiberboard (MDF) is attributable to three primary variables which are: physical and mechanical properties of individual wood fibers; fiber-to-fiber stress transfer; and fiber orientation. These origins of fiber properties and stress transfer can be traced to the fiber generation method wherein fiber orientation is associated with mat formation...

The creep behavior of basalt fiber reinforced epoxy (BFRE) and glass fiber reinforced epoxy (GFRE) composites was studied through tensile testing at high temperature. To study the effect of reinforcing epoxy, the micro glass powder (MGP) was added at various volume percentage into the epoxy resin in BFRE composites. The initial strain for all the specimens were evaluated and compared with each ...

Effect of addition of filler material to the natural fiber composite was experimentally investigated. Composites are manufactured by the conventional hand-layup method. All composites are made with a fixed banana fiber with 15% weight fraction addition of different weight fraction of (0, 3, 5, 7.5%) groundnut shell ash is added to the composite. Tensile, hardness, impact and compressive strengt...

The paper presents review of research work experimental investigation on polypropylene fibre reinforced concrete and concrete with artificial sand. Use of fiber reinforce polymer in civil engineering increase rapidly. Various type of fiber is used such as glass, carbon, steel, asbestos, polyester and polypropylene. The various experimental investigations for determination of properties of polyp...

A laser fusion joining method is investigated for the purpose of through thickness strengthening of fiber pre-forms used in the vacuum infusion fabrication of thick composite structures. Laser joining is achieved without filler materials to replace adhesives, pins or stitches used in conventional composite fabrication. A two step joining process is developed to fuse fibers within a single bundl...

In this paper, the compressive behavior of fiber-reinforced concrete with end-hooked steel fibers has been investigated through a uniaxial compression test in which the variables were concrete compressive strength, fiber volumetric ratio, and fiber aspect ratio (length to diameter). In order to minimize the effect of specimen size on fiber distribution, 48 cylinder specimens 150 mm in diameter ...

PURPOSE Among the surface treatment methods suggested to enhance the adhesion of resin cement to fiber-reinforced composite posts, conflicting results have been obtained with silanization. In this study, the effects of silanization, heat activation after silanization, on the bond strength between fiber-reinforced composite post and resin cement were determined. MATERIALS AND METHODS Six group...