Electrical discharge machining process, is one of the most widely used methods for machining, the electrically conductive parts. In this way the tool is not in contact with the workpiece and the hardness of workpiece does not affect the machining speed. In Electrical Discharge Machining process, selection of the correct machining parameters are effective in final cost and the quality of the pro...

PURPOSE The goal of this study was to evaluate the effect of vascular compliance, resistance, and pulse rate on the resistive index (RI) by using an electrical circuit model to simulate renal blood flow. METHODS In order to analyze the renal arterial Doppler waveform, we modeled the renal blood-flow circuit with an equivalent simple electrical circuit containing resistance, inductance, and ca...

s Some zirconia foams are used as heating elemeht in electrical furnaces. Their creep behaviour has been investigated at high temperature and under low stress. Important visco-elastic behaviour has been observed. It is likely due to recrystallization, which is sensitive to the tetragonal-cubic phase transition and to the stress. I INTRODUCTION Porous and dense zirconia based ceramics have been ...

Rationale: Electrical conduction through gap junction channels between endothelial cells of resistance vessels is integral to blood flow control. Small and intermediate-conductance Ca -activated K channels (SKCa/IKCa) initiate electrical signals in endothelial cells, but it is unknown whether SKCa/IKCa activation alters signal transmission along the endothelium. Objective: We tested the hypothe...

Peripheral nerve blocks are common and effective means for anesthesia for limb surgery. The evaluation of the success of a peripheral blockade is based on the loss of sensation, with no objective means of detecting a successful block. The autonomic innervation to the upper extremity, which controls both the vascular tone and the activity of sweat glands, is supplied by nerve fibers accompanying...

Different mineral admixtures of Indian metakaolin, Iranian silica fume and nanosilica were used to produce high performance mortars. Two different sands types with grain size of 0.015-4mm were mixed with type II Portland cement, polycarboxylate superplasticizer,mineral admixture with 650kg/m3 cement content and water/cement ratio of 0.35. Different amount of cement was replaced by metakaolin or...

Nanocomposites films of (polymer blend-ceramics) were prepared from (PVA-PAA) blend and (PVA-PAA) blend doped with niobium carbide nanoparticles for humidity sensors have low cost, easy fabrication, high sensitivity, lightweight and high corrosion resistance. The structural, electrical and optical properties of (PVA-PAA-NbC) nanocomposites have been studied. The D.C electrical properties of (PV...