The formation of hexadecane-in-water emulsions stabilised by montmorillonite platelets was studied. In this system the platelets form a monolayer around the droplets and the droplet size decreases with increasing platelet volume fraction. However, the number of platelets present exceeds that required for monolayer coverage. The kinetics of emulsification were investigated and coalescence of dro...

Unraveling structural dynamics of noble metal nanoclusters on oxide supports is critical to understanding reaction process and origin of catalytic activity in heterogeneous catalysts. Here, we show that aberration-corrected scanning transmission electron microscopy can provide direct atomic-resolution imaging of surface migration, coalescence, and atomic rearrangement of Au clusters on an Y:ZrO...

The expected universal dynamics associated with the initial stage of droplet coalescence are difficult to study visually due to the rapid motion of the liquid and the awkward viewing geometry. Here we employ an electrical method to study the coalescence of two low-viscosity droplets at early times. We measure the growth dynamics of the bridge connecting the two droplets and observe a new asympt...

The partial coalescence of a droplet onto a planar liquid-liquid interface is investigated experimentally by tuning the viscosities of both liquids. The problem mainly depends on four dimensionless parameters: The Bond number (gravity vs surface tension), the Ohnesorge numbers (viscosity in both fluids vs surface tension), and the density relative difference. The ratio between the daughter drop...

e consider the effects of adding a PIB-PDMS diblock copolymer as a compatibilizer in model lends composed of polyisobutylene PIB and polydimethylsiloxane PDMS . The ratio of PIB to DMS was varied from 20:80 to 80:20 and, hence, these blends are dubbed “concentrated” blends. ost experiments were conducted on blends containing 0.01 or 0.1 wt. % compatibilizer. All lends had a droplet-matrix morph...

A simple experimental setup to study the impact and coalescence of deposited droplets is described. Droplet impact and coalescence have been investigated by high-speed particle image velocimetry. Velocity fields near the liquid-substrate interface have been observed for the impact and coalescence of 2.4 mm diameter droplets of glycerol∕water striking a flat transparent substrate in air. The exp...

The coalescence of polymer droplets is a fundamental phenomenon which appears for example when mixing two polymers. When two polymeric droplets collide, a transient regime appears, which results from a competition between interfacial and viscoelastic effects : the spherical droplets deform to give birth to a new drop in a short time (tc) and the drop shape stabilizes after a long time. A novel ...

In this study, the recoil and oscillation of single and consecutively printed drops on substrates of different wettabilities are examined using a high speed camera. The results show that, for a droplet impact on a dry surface at Weber number ~ O (1), both inertia and capillary effects are important in the initial spreading regime before the droplet starts to oscillate. For a substrate of higher...

A three-dimensional boundary-integral algorithm is used to study thermocapillary interactions of two deformable drops in the presence of bulk-insoluble, non-ionic surfactant. The primary effect of deformation is to slow down the rate of film drainage between drops in close approach and prevent coalescence in the absence of van der Waals forces. Both linear and non-linear models are used to desc...

With the scaling of CMOS transistors and advance in I/O circuitry, the data rate of memory interfaces has recently reached 16Gb/s per channel [1], in which a point-to-point channel is required rather than a multi-drop channel for the high data rate. While point-to-point channels are advantageous in achieving higher data rates because of the absence of undesired reflections that occur at each st...